Skip to code content (skip section selection)
Compare to:
SEC. 91.7103.  GENERAL METHANE MITIGATION REQUIREMENTS.
 
   All new buildings and paved areas located in a Methane Zone or Methane Buffer Zone shall comply with these requirements and the Methane Mitigation Standards established by the Superintendent of Building.  The Methane Mitigation Standards provide information describing the installation procedures, design parameters and test protocols for the methane gas mitigation system, which are not set forth in the provisions of this division.
 
   Boundaries of the Methane Zones and Methane Buffer Zones are shown on the "Methane and Methane Buffer Zones Map" designated as Map number A-20960, dated September 21, 2003, which is attached to Council File No. 01-1305 or the most recent version of the described map.  (Amended by Ord. No. 185,587, Eff. 7/16/18.)
 
   Equipment and Systems.  All devices, components and equipment installed in any methane detection system shall be approved by the Fire Department as set forth in Fire Prevention Bureau (F. P. B.) Requirement No. 71.  (Added by Ord. No. 180,619, Eff. 5/12/09.)