1117.01 Construction plan; profile; cross sections.
1117.02 Engineering.
1117.03 Inspection.
1117.04 Supervision.
1117.05 Grading.
1117.06 Paving.
1117.07 Water system.
1117.08 Sanitary sewer system.
1117.09 Sidewalks.
1117.10 Storm drainage.
1117.11 Gas, telephone and electric lines.
1117.12 Street name signs.
1117.13 Construction and maintenance bond.
1117.14 Insurance.
1117.15 Street lighting.
CROSS REFERENCES
Improvements - see Ohio R.C. 711.101
Design standards - see P. & Z. Ch. 1115
Construction specifications - see P. & Z. Ch. 1119
Prior to the submission of the plat for approval by the Planning Commission, the owner shall submit a complete construction plan and profile to the City Engineer at a scale of not smaller than one inch to forty feet horizontally and one inch to four feet vertically, in material suitable to the City Engineer twenty-four inches by thirty-six inches, showing the proposed grading, drainage, paving, sanitary sewers and water lines within the subdivision. Such plan shall be accompanied by cross sections of the proposed streets, at a scale of not smaller than one inch to ten feet, in material suitable to the City Engineer twenty-four inches by thirty-six inches. Such cross sections shall be taken at intervals not exceeding fifty feet along the center line of such streets, and shall extend to the extreme width limits of the streets. Such cross sections shall show the contour of the existing ground and the contour of the proposed pavement, walks and finish grading, and the relative location of the proposed sewers and water lines. Such plan shall include the following information:
(a) Name of proposed subdivision.
(b) North arrow, scale, date and benchmark with elevation above sea level on each sheet.
(c) Typical cross section of the proposed street right of way showing in detail the pavement design, sidewalks and the relative location of the proposed water line, sanitary sewer, storm sewer and gas line. (Ord. 1961-3. Passed 7-31-61.)
It shall be the duty of the owner to employ Registered Professional Engineers, State of Ohio, to prepare the construction plans and to stake out the work in the field in accordance with the approved plans. Grade and line stakes shall be set at intervals not exceeding twenty-five feet for all vertical and horizontal curves, and at fifty-foot maximum spacing on tangents. Such stakes shall be protected until their use is no longer needed.
Matters in question regarding the design or stake-out of the work shall be referred to the City Engineer for his interpretation. (Ord. 1961-3. Passed 7-31-61.)
It shall be the duty of the City Engineer or Inspector to act in behalf of the City to see that all improvements are constructed in accordance with the plans and specifications thereof. No grading, paving or installation of any of the various utilities shall be done in the absence of a City Engineer or Inspector. The presence of a City Engineer or Inspector on the job shall in no manner relieve the owner from his responsibility to do the work in accordance with the approved plans and specifications thereof. (Ord. 1961-3. Passed 7-31-61.)
Loading...