Skip to code content (skip section selection)
Compare to:
Sacramento Overview
Sacramento, CA Code of Ordinances
SACRAMENTO CITY CODE
CHARTER
Title 1 GENERAL PROVISIONS
Title 2 ADMINISTRATION AND PERSONNEL
Title 3 REVENUE AND FINANCE
Title 4 ETHICS AND OPEN GOVERNMENT
Title 5 BUSINESS LICENSES AND REGULATIONS
Title 6 (RESERVED)
Title 7 (RESERVED)
Title 8 HEALTH AND SAFETY
Title 9 PUBLIC PEACE, MORALS AND WELFARE
Title 10 VEHICLES AND TRAFFIC
Title 11 (RESERVED)
Title 12 STREETS, SIDEWALKS AND PUBLIC PLACES
Title 13 PUBLIC SERVICES
Title 14 (RESERVED)
Title 15 BUILDINGS AND CONSTRUCTION
Title 16 (Reserved)
Title 17 PLANNING AND DEVELOPMENT CODE
Title 18 ADDITIONAL DEVELOPMENT REQUIREMENTS
TABLES
Chapter 17.340
TO ZONE-TRANSIT OVERLAY
Sections:
17.340.010   TO zone-Purpose.
17.340.020   TO zone-Applicability.
17.340.030   Uses in the RMX-TO zone.
17.340.040   Uses in the C-2-TO zone.
17.340.050   TO zone-Prohibited uses.
17.340.060   TO zone-Development standards.
17.340.010   TO zone-Purpose.
The TO zone allows a mix of moderate- to high-density residential and nonresidential uses by right, within walking distance of an existing or proposed light rail transit station, to promote transit ridership. This overlay zone is intended to promote coordinated and cohesive site planning and design that maximize transit-supportive development; to create continuity of pedestrian-oriented streetscapes and activities; and to encourage pedestrian, bicycle, and transit-rather than exclusive automobile access-to employment, services, and residences. This zone permits increased heights, densities, and intensities over the underlying zone for projects with a residential component; and encourages housing and mixed-use projects. This zone also restricts certain uses that do not support transit ridership. (Ord. 2013-0020 § 1; Ord. 2013-0007 § 1)
17.340.020   TO zone-Applicability.
   A.   The TO zone may be applied to RMX and C-2 zoned property any portion of which is located within a one-half mile radius of an existing or proposed light rail transit (LRT) station. The one-half mile radius is measured as follows:
      1.   For existing stations, from the center of the station platform, as determined by the planning director, to the edge of the property closest to the station.
      2.   For proposed stations, from the center point of the block designated for the station to the edge of the property closest to the center of the designated block.
   B.   A "TO" designation appearing after a RMX or C-2 zone classification on the official zoning map means the property is subject to the requirements and restrictions set forth in this chapter in addition to those of the underlying zone, unless otherwise specified. If a conflict exists between the provisions in this chapter and other provisions of this title, the provisions of this chapter prevail. (Ord. 2013-0020 § 1; Ord. 2013-0007 § 1)
17.340.030   Uses in the RMX-TO zone.
   A.   Except as provided in section 17.340.050, uses permitted in the RMX zone outside of a TO zone are permitted in the RMX-TO zone. If this title requires the approval of a conditional use permit or other discretionary entitlement, or imposes other restrictions or requirements on the establishment of a particular use in the RMX zone outside of a TO zone, approval of the same discretionary entitlement and compliance with the same restrictions or requirements are required to establish the use within the RMX-TO zone.
   B.   In addition to uses permitted under subsection A, the following use is permitted in the RMX-TO zone:
      1.   Hotel; motel. (Ord. 2013-0020 § 1; Ord. 2013-0007 § 1)
Loading...