18-29-705.2 Deliberately omitted.

18-29-705.3 Deliberately omitted.

18-29-705.4 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. VII, § 5, repealed § 18-29-705.4, which had pertained to brass.

18-29-705.4.1 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. VII, § 5, repealed § 18-29-705.4.1, which pertained to brazed joints.

18-29-705.4.2 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. VII, § 5, repealed § 18-29-705.4.2, which pertained to mechanical joints..

18-29-705.4.3 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. VII, § 5, repealed § 18-29-705.4.3, which pertained to threaded joints.

18-29-705.4.4 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. VII, § 5, repealed § 18-29-705.4.4, which pertained to welded joints.

18-29-705.5 Cast iron.

   Joints between cast-iron pipe or fittings shall comply with Sections 18-29-705.5.1 through 18-29-705.5.3.

18-29-705.5.1 Caulked joints.

   Joints for hub and spigot pipe shall be firmly packed with oakum or hemp. Molten lead shall be poured in one operation to a depth of not less than 1 inch (25 mm). The lead shall not recede more than 1/8 inch (3 mm) below the rim of the hub and shall be caulked tight. Paint, varnish or other coatings shall not be permitted on the jointing material until after the joint has been tested and approved. Lead shall be run in one pouring and shall be caulked tight. Acid-resistant rope and acid-proof cement shall be permitted.