18-29-303.1 Identification.

   Each length of pipe and each pipe fitting, trap, fixture, material and device utilized in a plumbing system shall bear the identification of the manufacturer and any markings required by applicable referenced standards.

(Amend Coun. J. 10-14-21, p. 37722, Art. III, § 4)

18-29-303.2 Installation of materials.

   Materials used shall be installed in strict accordance with the standards under which the materials are accepted and approved. In the absence of such installation procedures, the manufacturer's instructions shall be followed. Where the requirements of referenced standards or manufacturer's instructions do not conform to minimum provisions of this chapter, the provisions of this chapter shall apply.

(Amend Coun. J. 10-14-21, p. 37722, Art. III, § 4)

18-29-303.3 Plastic pipe, fittings and components.

   Plastic pipe, fittings and components shall be third-party certified as conforming to NSF 14.

(Amend Coun. J. 10-14-21, p. 37722, Art. III, § 4)

18-29-303.4 Third-party certification.

   Plumbing products and materials required by this chapter to be in compliance with a referenced standard shall be listed by a third-party certification agency as complying with the referenced standard. Products and materials shall be identified in accordance with Section 18-29-303.1.

(Amend Coun. J. 10-14-21, p. 37722, Art. III, § 4)

18-29-303.4.1 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. III, § 4, repealed § 18-29-303.4.1, which pertained to testing.

18-29-303.4.2 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. III, § 4, repealed § 18-29-303.4.2, which pertained to inspection and identification.

18-29-303.4.2.1 Reserved.

Editor's note – Coun. J. 10-14-21, p. 37722, Art. III, § 4, repealed § 18-29-303.4.2.1, which pertained to independent.