1255.07   DEVELOPMENT STANDARDS.
   Regulations regarding lot dimensions, building setbacks, building heights, and unit sizes shall be established as part of the development plan approval by the Planning Commission, guided by the following:
   (a)   Lot Requirements. Lot sizes and lot widths may be varied to allow for a variety of structural designs and mix of dwelling types.
   (b)   Minimum Setback from Street Right-of-Way. With a preference towards building fronts facing the street right-of-way (ROW), building structures and parking areas shall be setback a minimum of 35 feet from an existing street right-of-way Where 20% or more of the aggregate street frontage of the abutting property between two successive intersecting streets is occupied by buildings, the average of the setbacks of the existing buildings within 100 feet on either side of the lot may be used to determine the setback line for that lot.
   (c)   Maximum Height. Buildings shall not exceed the height specified below based on the dwelling type:
      (1)   One-family detached: 35 feet.
      (2)   One-family attached: 35 feet.
      (3)   Two-family dwelling: 35 feet.
      (4)   Condominium: 35 feet.
   (d)   Dwelling Unit Area Requirements. Regardless of dwelling type, the size of dwelling units should comply with the minimum dwelling unit area requirements set forth in Section 1254.07 (b) based on the number of bedrooms in the unit.
   (e)   Parking Spaces.
      (1)   The number of off-street parking spaces provided shall comply with Section 1280.03, based on the type of unit(s).
      (2)   No parking space shall be less than 180 square feet in area (drives, curbs and turning spaces excluded). The minimum width shall be nine (9) feet.
      (3)   Traffic moving areas between parallel parking spaces shall not be less than eighteen (18) feet wide.
      (4)   Additional regulations as outlined in Section 1610.04
   (f)   Utilities. All means of transmitting or carrying utilities, including street lights, within the PUD shall be located underground. Refuse collection bins shall be shielded from view and kept in a sanitary condition at all times.
(Ord. 2022-O-19. Passed 11-22-22.)