Loading...
Fences or walls within all Residential (R) Zones including their applicable Overlay Zone shall conform to the following requirements:
A. The requirements for the Residential (R) Zones for residential uses only, are as set forth and depicted on Figure 2 of this section.
B. The location, height, and type of all fences and/or walls within any area zoned with a PUD, RCD, or MHP Overlay shall be as approved by the Planning Commission.
C. For all nonresidential uses conditionally permitted in any residential zone herein, the requirements are as follows:
1. Fences of class two or three only shall be permitted in front yards including the front yard of corner lots as governed by § 13.0. Said fences may be erected up to a maximum height of 72 inches.
2. Classes one, two, three, four, five, and six fences or walls may be erected in side or rear yards up to a maximum height of 72 inches; provided, however, for the following exceptions:
a. General purpose recreational areas may be enclosed with fences or walls of class one, two, three, four, five, six, or seven, up to a maximum height of 96 inches.
b. Class three fences (or a combination of three and seven) may be erected to enclose tennis courts or as backstops for baseball and or softball fields up to a maximum height of 144 inches; and
c. In the case of corner lots, as governed by § 13.0, fences of class two or three only may be erected, as regulated by the applicable provisions of the section.
(Ord. 2017-6, passed 4-4-17)
Fences and/or walls within all commercial & industrial zones, including those permitted with all conditionally permitted uses in this zone shall conform to the following requirements:
A. Except as provided for in § 13.0, fences of classes one, two, three, four, five, or six may be erected in front, side, and rear yards of commercial zones up to a maximum height of 96 inches. In the case of corner lots, as governed by § 13.0, fences of class two or three only may be erected up to a maximum height of 96 inches. In minimum front yard, fences of classes one, two, three, four, five, or six may be erected up to a maximum height of 72 inches.
B. Except as noted in § 13.0, fences of classes one, two, three, four, five, or six may be erected up to a maximum height of 84 inches in all industrial zones in side and rear yards and not more than 48 inches in height in the minimum front yard depth. Except for the I-P zone, classes two or three fences may be erected up to a maximum height of 72 inches in the minimum front yard depth in all industrial zones.
(Ord. 2017-6, passed 4-4-17)
In all zones barbed wire or sharp pointed fences, where permitted, must start a minimum of 60 inches above ground level, except that those fences may be located in area uses for agricultural purposes without any restrictions to height.
(Ord. 2017-6, passed 4-4-17)
A combination fence and retaining wall may be erected. The retaining wall portion may be erected up to the level of the higher finished grade. The fence portion must be of the class and height permitted within this appendix for the applicable zone. The measurement shall be made at and along the location of the fence and retaining wall.
(Ord. 2017-6, passed 4-4-17)
(Ord. 2017-6, passed 4-4-17)
Loading...