Skip to code content (skip section selection)
Compare to:
Dayton Overview
Dayton, KY Code of Ordinances
DAYTON, KENTUCKY CODE OF ORDINANCES
ADOPTING ORDINANCES
TITLE I: GENERAL PROVISIONS
TITLE III: ADMINISTRATION
TITLE V: PUBLIC WORKS
TITLE VII: TRAFFIC CODE
TITLE IX: GENERAL REGULATIONS
TITLE XI: BUSINESS REGULATIONS
TITLE XIII: GENERAL OFFENSES
TITLE XV: LAND USAGE
CHAPTER 150: BUILDING REGULATIONS
CHAPTER 151: FENCES
CHAPTER 152: FLOOD DAMAGE PREVENTION
CHAPTER 153: UNIFORM RESIDENTIAL LANDLORD AND TENANT ACT
CHAPTER 154: ZONING CODE
CHAPTER 155: SUBDIVISION REGULATIONS
CHAPTER 156: HISTORIC PRESERVATION
CHAPTER 157: REGISTRATION OF VACANT REAL PROPERTY
CHAPTER 158: REASONABLE ACCOMMODATIONS IN RESIDENTIAL NEIGHBORHOODS
TABLE OF SPECIAL ORDINANCES
PARALLEL REFERENCES
Loading...
SECTION 13.4 COMMERCIAL AND INDUSTRIAL ZONES.
   Fences and/or walls within all commercial & industrial zones, including those permitted with all conditionally permitted uses in this zone shall conform to the following requirements:
   A.   Except as provided for in § 13.0, fences of classes one, two, three, four, five, or six may be erected in front, side, and rear yards of commercial zones up to a maximum height of 96 inches. In the case of corner lots, as governed by § 13.0, fences of class two or three only may be erected up to a maximum height of 96 inches. In minimum front yard, fences of classes one, two, three, four, five, or six may be erected up to a maximum height of 72 inches.
   B.   Except as noted in § 13.0, fences of classes one, two, three, four, five, or six may be erected up to a maximum height of 84 inches in all industrial zones in side and rear yards and not more than 48 inches in height in the minimum front yard depth. Except for the I-P zone, classes two or three fences may be erected up to a maximum height of 72 inches in the minimum front yard depth in all industrial zones.
(Ord. 2017-6, passed 4-4-17)
SECTION 13.5 MEASUREMENT OF ALL FENCE OR WALL HEIGHTS AND LOCATIONS.
   A.   All fences and/or walls heights shall be measured along the fence or wall locations.
   B.   All locations for distance measurements shall be measured from lot lines.
(Ord. 2017-6, passed 4-4-17)
SECTION 13.6 HEIGHT OF ANY BARBED WIRE OR SHARP POINTED FENCES.
   In all zones barbed wire or sharp pointed fences, where permitted, must start a minimum of 60 inches above ground level, except that those fences may be located in area uses for agricultural purposes without any restrictions to height.
(Ord. 2017-6, passed 4-4-17)
Loading...