(a) Front Yard. Front yard setbacks shall be not less than established in the above schedule unless shown otherwise on the Zone Map, except that the front yard setback along both sides of Progress Drive shall not be less than thirty feet and the front yard setback along both sides of Alameda Drive shall not be less than seventy feet. If a portion of the front yard is used for parking in accordance with the above schedule, a poured concrete curb or precast concrete barrier shall be erected or installed along the parking area line not less than the distance set forth above from the front property line, and the yard between the curb or barrier and the street line shall be attractively landscaped and maintained.
(b) Side and Rear Yard. Side and rear yards, where adjoining a Residential District, shall be provided as set forth in the above schedule and shall apply to all buildings, structures and parking and open yard uses. However, the side and rear yards may be less than scheduled for the addition and alteration to a service, storage or industrial building existing on the effective date of this Zoning Code (Ordinance 1978-165, passed October 16, 1978), if approved by the Planning Commission. A solid fence approximately five to seven feet high shall be required by the Planning Commission along a side or rear yard line of a Research-development, Commercial Service, General Industrial or General Industrial-A lot where adjoining a residential lot.
(c) Side Yard on Corner Lot. Whenever an industrial building is located on a corner lot, the width of the side yard on the side street shall be not less than fifty feet in Research-Development, General Industrial and General Industrial-A Districts and twenty-five feet in Commercial Service and Aviation Field Districts. The parking setback from the side street shall be not less than twenty-five feet.
(d) Location of Drives. Location of drives relative to off-street parking areas shall comply with the parking setback requirements of Section 1262.07
.
(Ord. 2001-150. Passed 4-8-02.)