(A) The final plat will have incorporated all changes or modifications required by the Planning Commission and Village Engineer, otherwise it shall conform to the preliminary plat, and it may constitute only that portion of the approved preliminary plat which the developer proposed to record and develop at the time; provided that such portion conforms with all requirements of this chapter.
(B) The final plat shall be prepared by a registered surveyor if any new parcels and/or lots have been created and shall be clearly and legibly drawn with permanent ink. The size of the plat shall be on one or more sheets 20 inches by 20 inches. Scale shall be one inch equals 50 feet. If more than two sheets are required, an index sheet must be filed showing the entire subdivision on one sheet with all areas shown on other sheets indicated thereon.
(C) The final plat shall contain the following information:
(1) Name of the subdivision; location, date, north point, graphic and numerical scale, and total acreage;
(2) All plat boundaries with length of courses in feet and hundredths, bearings to not more than half minutes. All surveys must be done to state minimum standards;
(3) Bearings and distances to the nearest established street lines or other recognized permanent monuments, which shall be accurately described on the plat;
(4) Exact locations of adjoining and proposed streets and alleys with their widths and names plus building setback lines;
(5) All easements and rights-of-way provided for public services or utilities, and any limitations of such rights-of-way or easement;
(6) All lot numbers and lines, with accurate dimensions in feet and hundredths, and with bearings. The basis of bearings shall be stated on plat. The acreage of all lots over one acre in size shall be indicated;
(7) Names and addresses of the developer and the qualified surveyor who prepared the final plan;
(8) Accurate outlines of any areas to be dedicated or temporarily reserved for public use or any area to be reserved for common uses of all property owners;
(9) A list of all restrictions and covenants the developer intends to include in the deeds to the lots in the subdivision shall accompany the final plat and shall be recorded prior to final plat approval. Reference to their recording shall be made on the final plat;
(10) Certification by a registered surveyor to the effect that the plat represents a survey made by him or her and that all monuments shown thereon exist as located and that all dimensional details are correct;
(11) An acknowledgment by the owner or owners of his or her or their adoption of the plat, and dedication of streets and other public areas;
(12) Vicinity map of area within one-half mile radius except that this requirement may be waived where the area is located in a mapped area within the municipality or section contiguous thereto; and
(13) Lot numbers and corresponding house numbers.
(Ord. O-28-2021, passed 11-16-2021)