A. Antenna mounted on existing building or structure-General. Except as provided in section 17.808.160 and subsections B, C, and D of this section, and except for an antenna subject to sections 17.228.310 or 17.228.320, an antenna mounted on an existing building or structure, together with related equipment, is subject to director-level site plan and design review and shall conform to the following development standards:
1. The antenna, and its related equipment, shall not project above the roof parapet or penthouse roof line of the building, or the highest point of the structure to which the antenna is attached, by more than 12 feet.
2. The antenna, and its related equipment, shall not extend out more than six feet from the face of the building or surface of the structure to which is it attached.
3. The antenna panels and all brackets and cables shall be painted to match the building or structure at the point of attachment.
4. The equipment cabinet, if any, is located in one of the following locations:
a. On the roof of, or within, the building or structure on which the antenna is mounted;
b. Within any building located on the same parcel as the building or structure on which the antenna is mounted; or
c. On the ground and outside of any required setback or parking area on the same parcel as the building or structure on which the antenna is mounted.
5. An equipment cabinet located on a building roof shall conform to the requirements for roof-mounted mechanical equipment in chapter 17.600.
B. Antenna mounted on an existing building or structure-Single-unit and duplex dwellings. An antenna shall not be mounted on the exterior of a single-unit or duplex dwelling.
C. Antenna mounted on an existing building or structure-Antenna not visible from adjacent streets or public areas. An antenna mounted on an existing building or structure, together with related equipment, that is not visible from adjacent streets or public areas, is subject to staff-level site plan and design review.
D. Antenna mounted on an existing building or structure-Panel antenna.
1. Site plan and design review.
a. General. Except as provided in subsection b, a panel antenna mounted on an existing building or structure, together with related equipment, is subject to staff-level site plan and design review.
b. Historic resources. A panel antenna mounted on a landmark or on an existing building or structure in a historic district, together with related equipment, is permitted subject to director-level site plan and design review.
2. Development standards. A panel antenna mounted on an existing building or structure, together with related equipment, shall conform with the following development standards:
a. The antenna, and its related equipment, shall not project above the roof parapet or penthouse roof line of the building, or the highest point of the structure to which the antenna is attached.
b. The antenna, and its related equipment, shall not extend out more than 18 inches from the face of the building or surface of the structure to which is it attached.
c. The antenna panels and all brackets and cables shall be painted to match the building or structure at the point of attachment.
d. The equipment cabinet, if any, shall be located in one of the following locations:
i. On the roof of, or within, the building or structure on which the antenna is mounted;
ii. Within any building located on the same parcel as the building or structure on which the antenna is mounted; or
iii. On the ground and outside of any required setback or parking area on the same parcel as the building or structure on which the antenna is mounted.
e. An equipment cabinet located on a building roof shall conform to the requirements for roof-mounted mechanical equipment in chapter 17.600. (Ord. 2019-006 § 6; Ord. 2013-0020 § 1; Ord. 2013-0007 § 1)