(a) Accessory Buildings. Accessory buildings that have a gross floor area of 200 square feet or less shall be located in a side or rear yard and shall comply with the parking setbacks set forth in Schedule 1171.11. All other buildings shall be considered principal buildings and shall conform to all lot and setback regulations and development plan review and approval requirements of the zoning district in which the parcel or lot is located.
(b) Fences and Walls. Fences and walls may be erected in the Industrial District in compliance with the requirements set forth below:
(1) Location.
A. Fences may be built up to, but not on, the property line, and shall be located entirely on the property of the person constructing it, except property owners, with written permission from abutting property owners, may connect to fences on adjoining properties.
B. In order to maintain clear vision lanes for vehicles and pedestrians, no opaque fences shall be permitted within ten (10) feet, in any direction, of the following points:
1. At the intersection of a driveway and sidewalk (or front property line if there is no sidewalk);
2. At the intersection of a driveway and public right-of way;
3. At the intersection of any two driveways.
(2) Materials and Construction.
A. Approved fencing materials include stone, brick, finished wood, iron, vinyl covered chain link, or synthetic look-alike products, except as otherwise provided for in this Section.
B. No fence shall be electrified or topped with barbed or razor wire, except when permitted by the Planning Commission in order to promote public health and safety. If the Planning Commission approves such fencing, the electrified, barbed or razor wire shall be mounted at least eight (8) feet above the average grade and no more than three (3) stands of barbed or razor wire shall be permitted.
C. Only ornamental fences shall be permitted in front of a building, unless required for screening pursuant to Chapter 1185, Landscaping & Screening Regulations. The Planning Commission may permit other types of fencing in front of the building, when the applicant can demonstrate just cause for such fencing, such as security needs.
D. All fences shall be designed, constructed, and finished so that the supporting members face the property of the owner of the fence.
E. All fences on a single parcel shall have a unified style along a single plane and for all fence segments visible from off the premises from any single direction.
(3) Height. No fence shall exceed six (6) feet in height in any rear or side yard, or exceed three (3) feet in height when located in front of a building, unless otherwise required by this Development Code.
(4) Screening and Landscaping.
A. Screening and landscaping is not required for ornamental fences.
B. All fences, other than ornamental fences, when visible from public streets, shall be visually softened and reasonably screened from the street with appropriate landscaping as follows:
1. Fences that are located within required building and parking setbacks shall be considered appropriately screened with the landscaping required in Section 1185.07
, Landscaping along the Street Frontage and Parking Setback, is planted within five (5) feet of the fence and between the fence and the property line.
2. Fences that are not located within the required setback areas shall be screened with the following landscape materials, planted not more than five (5) feet from the fence and between the fence and the property line:
(I) One shade tree shall be provided for every thirty (30) linear feet of fence length or fraction thereof, not including gates or other fence openings. Each tree at the time of installation shall have a minimum caliper of 2.5 includes and a clear trunk height of at least six (6) feet;
(II) One shrub, that is twenty-four (24) inches in height at planting, shall be provided for every five (5) feet fence length or fraction thereof, not including gates or other fence openings; and,
(III) The landscaping may be flexible in its arrangement by appropriately aggregating the required plant materials.
(5) All fences shall be maintained in good condition, be structurally sound and attractively finished at all times.
(6) Any proposed fence shall be approved as part of a Development Plan Review in accordance with Chapter 1127.