The following requirements shall apply to all locations and developments at which land disturbing activities have occurred previous to the enactment of this chapter:
A. Areas Vegetated: Denuded areas must be vegetated or covered under the standards and guidelines specified in the BMP manual and on a schedule acceptable to the division;
B. Covered Cuts And Slopes: Cuts and slopes must be properly covered with appropriate vegetation or secured in a riprap channel lining, etc., to prevent erosion;
C. Cleared Obstructions: Trash, junk, rubbish, or any obstruction shall be cleared from drainageways;
D. Controlled Runoff: Stormwater runoff shall be controlled to the extent reasonable to prevent pollution of waters. Such control measures may include, but are not limited to, the following:
1. Ponds:
a. Detention pond;
b. Extended detention pond;
c. Wet pond; and
d. Alternative storage measures.
2. Constructed wetlands.
3. Infiltration systems:
a. Infiltration/percolation trench;
b. Infiltration basin;
c. Drainage (recharge) well; and
d. Porous pavement.
4. Filtering systems:
a. Catch basin inserts/media filter;
b. Sand filter;
c. Filter/absorption bed; and
d. Filter and buffer strips.
5. Open channel:
a. Swale.
E. Requirements For Existing Problem Locations: The division shall, in writing, notify the owners of existing locations and developments of specific drainage, erosion or sediment problems affecting such locations and developments, and the specific actions required to correct those problems. The notice shall also specify a reasonable time for compliance.
F. Inspection Of Existing Facilities: The division may, to the extent authorized by State and Federal law, establish inspection programs to verify that all stormwater management facilities, including those built before as well as after the adoption of this chapter, are functioning within design limits. These inspection programs may be established on any reasonable basis, including, but not limited to, routine inspections; random inspections; inspections based upon complaints or other notice of possible violations; inspection of drainage basins or areas identified as higher than typical sources of sediment or other contaminants or pollutants; inspections of businesses or industries of a type associated with higher than usual discharges of contaminants or pollutants; and joint inspections with other agencies inspecting under environmental or safety laws. Inspections may include, but are not limited to:
1. Reviewing maintenance and repair records;
2. Sampling discharges, surface water, ground water, and material or water in drainage control facilities; and
3. Evaluating the condition of drainage control facilities and other BMPs.
G. Corrections Of Problems Subject To Appeal: Corrective measures imposed by the division under this section are subject to appeal under section 13.52.110 of this chapter. (Ord. 17-40)