In Commercial and Manufacturing Zones, signs indicating the business, commodities, service, industry, or other activity sold, offered, or conducted on the premises are permitted as follows:
A. Detached On-Site Signs: Detached on site signs are to be erected as follows:
1. One detached on premises sign for each developed parcel not exceeding one and one-half (11/2) square feet of sign area for each linear foot of street frontage. No sign may exceed a total sign area of two hundred (200) square feet per side (see figure 22 of this subsection A1). A maximum of two (2) sides are allowed;
FIGURE 22
2. If a developed parcel has in excess of two hundred (200) linear feet of street frontage, additional signs may be allowed, provided the distance between detached signs on each parcel may not be less than two hundred feet (200') as measured in a straight line;
3. The maximum sign height is thirty five feet (35') above pavement grade or ground level. On properties adjacent to freeways, where the sign is freeway oriented, maximum sign height may be determined from freeway grade;
4. Minimum sign clearance from grade to the bottom of the sign is eight feet (8');
5. Ground/monument signs shall comply with regulations found in section 17.48.140 of this chapter;
6. Minimum sign setback from all property lines is two feet (2').
7. Pole signs are only allowed in the Commercial and Manufacturing Zones for parcels or developments that are directly adjacent to or abutting either Interstate 15 or Interstate 215 and must be freeway oriented.
B. Attached Signs For Each Occupancy: On premises signs may not exceed a total of three (3) square feet of sign area for each linear foot of building frontage.
C. Planned Center Signs: The Planning Commission may allow common signs displaying advertising for all uses with a planned center on multiple parcels of property that may or may not have separate ownership. The Planning Commission will consider the following criteria as basis for approval of the signs:
1. Signs must be integrated into the development with a common theme or integrated architecturally with the buildings.
2. Location, number, and size of all signs must receive approval by the Planning Commission and meet the provisions within the Sign Code.
3. The applicant must submit elevations of all signs, and a site plan showing the location of the proposed signs.
4. Additional standards for pedestal signs are located within section 17.48.140 of this chapter.
D. Pylon Signs: Are permitted within the C-D Zone (not permitted within the M-G Zone) and shall comply with the regulations found in section 17.48.140 of this chapter. (Ord. 19-14)