§ 1165.04 DEVELOPMENT STANDARDS.
   The following development standards shall apply to I-2 Districts:
   (a)   Development standards.
Table 1165 - I-2 Development Standards
Table 1165 - I-2 Development Standards
Minimum lot area
5 acres
Maximum building height (a)
40 feet
Minimum Setback
Structures NOT abutting residential district (a)
 
   Front (b)
50 feet
   Side
12 feet
   Rear
10 feet
Structures abutting a residential district (a)
 
   Front
50 feet
   Side and rear
100 feet
Parking structures or paved areas
 
   Front (c)
25 feet
   Side and rear
10 feet
(a)   Minimum setbacks are for structures up to 40 feet in height. For each additional foot in height, the setback shall increase by two feet. No building shall exceed 90 feet in height.
(b)   For lots fronting on two streets, the front setback shall apply to both yards abutting the street right-of-way.
(c)   Excludes areas required for access to street.
 
   (b)   Off-street parking and loading. Off-street parking and loading facilities shall be provided as specified in Chapter 1175.
   (c)   Storage and unloading. All outside operations and storage of raw materials and/or manufactured products shall be behind the rear of the building and shall be sufficiently screened from view from the roadway and adjoining properties as determined by the Planning Commission to be necessary to conceal the operation and storage from view. Loading and unloading operations shall be conducted in the rear or side of the building and shall be sufficiently screened from view from the roadway and adjoining properties as determined by the Planning Commission to be necessary to conceal the loading and unloading operations from view.
   (d)   Exterior building material.
      (1)   Unfinished or unpainted non-decorative concrete block shall not be used on any exterior wall.
      (2)   Metal siding used on any wall shall be subject to the approval of Planning Commission.
      (3)   A combination of brick, masonry, glass, architectural metal wall panels, or other suitable building materials shall be used on the front facade of the building, subject to Planning Commission approval.
   (e)   Mechanical screening. All roof mounted mechanical equipment shall be screened from view from all adjacent property and zoning districts and from road rights-of-way in all zoning districts using durable, compatible, opaque materials.
(Ord. 2004-155, passed 1-10-2005; Ord. 2015-89, passed 9-28-2015)