(a) Generally. The following development standards shall apply to HT-1 Districts:
Minimum area of district | 10 acres | ||
Minimum lot area | 43,560 square feet per lot | ||
Minimum lot width | 150 feet | ||
Minimum lot depth | 200 feet | ||
Minimum setback requirements | Not abutting a residential district | Abutting a residential district | Abutting right of-way |
Front | 50 feet (a) | 50 feet (a) | 50 feet (a) |
Side | 15 feet (a) | 100 feet (a) | 50 feet (a) |
Rear | 25 feet (a) | 100 feet (a) | 50 feet (a) |
Maximum height | 60 feet (a) | ||
(a) Required setbacks are shown for a maximum height of 60 feet. For every one foot of height above the 60-foot maximum, each of the required front, side and rear yard setbacks are increased by two feet. No building shall exceed a maximum height of 90 feet. | |||
(Ord. 98-104, passed 9-14-1998)
(b) Storage/loading. All uses, including storage, loading and unloading shall be conducted entirely within an enclosed building. Loading and unloading activities shall satisfy the provisions of this division if:
(1) A vehicle or trailer is located sufficiently close to the exterior wall or loading dock of the building so that all loading and unloading occurs between the confines of the building and the interior of the vehicle or trailer; and
(2) The vehicle or trailer is located on the rear of the building and is sufficiently screened from view from the roadway and any adjoining properties as determined by the Planning Commission to be necessary to conceal the loading and unloading activities from view.
(Ord. 99-132, passed 10-11-1999)
(c) Off-street parking and loading.
(1) In addition to the requirements contained in division (b) above, off-street parking and loading facilities shall be provided as specified in Chapter 1175.
(2) Outside parking of any vehicle over 25 feet in length for a period of more than 24 hours is prohibited.
(3) Parking of fleet vehicles, as defined in § 1133.78, shall be prohibited in front of the building line, and outside parking of more than five fleet vehicles shall be prohibited unless completely screened from adjacent properties and public rights-of-way with a wall constructed of the same material as the principal building.
(d) Exterior building material.
(1) Unfinished or unpainted non-decorative concrete block shall not be used on any exterior wall.
(2) Metal siding shall not be used on any wall facing a public street or a residential district. If metal siding is utilized on any remaining wall, it shall be subject to the approval of Planning Commission.
(3) A combination of brick, masonry, glass, architectural metal wall panels, or other suitable building materials shall be used on the front facade of the building, subject to the approval by the Planning Commission.
(e) Mechanical screening. All roof mounted mechanical equipment shall be screened from view from adjacent property and zoning districts and from road rights-of-way in all zoning districts using durable, compatible, opaque materials.
(f) Fencing. In addition to the regulations in § 1185.02, any fencing proposed shall be subject to the approval of the Planning Commission.
(Ord. 2004-155, passed 1-10-2005; Ord. 2015-89, passed 9-28-2015)