All requests for development addressing shall be supported by a clearly legible address plat. The address plat shall be an accurate representation of 1) existing conditions; 2) approved final site plan; or 3) the approved record plat, depending on the nature of the request. All address plats shall be in conformance with the following requirements:
(A) Address plats are to be prepared on 24" x 36" paper prints or 4-mil scale-stable polyester film (mylar) for all requests at a scale of 1" = 50'. The Director of the Department may alter this requirement where the project will not fit on the designated sheet size.
(B) Addressable building footprints, and all exterior building entrance points shall be shown,
(C) Primary access to the site shall be shown.
(D) All interior hallways, units, apartments, etc., and interior entrance points.
(E) All boundaries of the property of properties for which an address is required shall be shown, along with subdivision name and lot numbers, as appropriate.
(F) Public rights-of-way and existing/proposed street names shall be shown.
(G) Ingress/egress easements and parking lots, and existing/proposed names shall be indicated.
(H) Driveway locations for all corner lots shall be shown.
(I) At least four (two easting and two northing) Virginia Coordinate Grid lines, in intervals evenly divisible by 500, with annotation, will be included grid. "Tics" are unacceptable.
(J) The address plat shall include a signature block, signed by the engineer/surveyor and worded as follows:
I hereby certify that the information on this address plat is consistent with (existing conditions) (approved record plat) (approved final site plan).
(DATE) (ENGINEER/SURVEYOR)
(K) A title block shall be included with project name.
(L) Vicinity map at a scale of 1" = 1000', except as may be noted in individual requests, shall be included.
(M) Tax Map and parcel identification number.
(Ord. 92-01. Passed 1-21-92.)