Loading...
An inspection fee as set forth from time to time by ordinance is required to inspect a building for the purpose of checking for compliance with or changing of the use group of, an existing building when no work is proposed which would otherwise require a building permit. However, this does not apply to one, two, or three-family dwellings.
('80 Code, § 1333.07) (Ord. 141-87, passed 12-21-87)
Editor's Note:
A copy of the most recent ordinance establishing current city fees and service charges is available at city offices during normal business hours.
In the event that work covered by any permit or inspection required by the building code is not installed or completed, or both, in accordance with the building code, thereby requiring one or more inspections, a fee for each reinspection shall be assessed.
('80 Code, § 1333.08) (Ord. 76-80, passed 11-3-80)
(A) Warm air heating and ventilation permits shall be required as follows:
(1) Residential. Only one warm air heating and ventilation permit shall be required for each residential building regulated by the Dublin Residential Code.
(2) Nonresidential. For all other buildings not included above, a separate warm air heating and ventilation permit shall be required for each certified address.
(3) Permits for alterations of existing, multi-story buildings shall require a separate permit for each floor, except that all floors occupied by a single tenant shall require only one permit.
(4) Whenever repair of a warm air heating device necessitates replacement of a heat exchanger or burner assembly a minimum fee shall be required.
(B) The minimum warm air heating and ventilation permit fee shall be as set forth from time to time by ordinance.
(C) Warm air heating and ventilating permit fees shall be assessed according to the following schedule:
(1) Warm air heating systems to include heating units, toilet room exhaust fans not exceeding 100 CFM, and all duct outlets and inlets. The permit shall describe devices installed and capacities of each device and the fee shall be based on the total installed BTU/hr.
(2) Ventilation permit fees for all types of ventilation systems, including but not limited to fans with no ducts, ducting systems, air handling systems, dust collecting systems, and makeup air systems shall be assessed according to the total CFM installed except as excluded in division (C)(1) hereof.
(D) Warm air heating and ventilating permits shall be required for alteration or extension of supply and return ducts where heating and ventilating systems are existing. Permit fees for the duct work shall be assessed according to a schedule as set forth from time to time by ordinance.
(E) Warm air heating and ventilation permits shall be required for gas or oil conversion burners and the fees for said permits shall be assessed as set forth from time to time by ordinance.
(F) Warm air heating and ventilating permits shall be required for dual-fuel burners where equipment is and has been existing but was installed and fired with one fuel on original permit. The permit shall be for installation and firing with the standby fuel and the fees for such permit shall be assessed as set forth from time to time by ordinance.
(G) Warm air heating and ventilation permits shall be required for infrared heaters and the fees for such permits shall be assessed, as set forth from time to time by ordinance, for the total BTU's.
(H) Warm air heating and ventilation permits shall be required for stokers and shall be assessed as set forth from time to time by ordinance.
(I) Warm air heating and ventilation permits shall be required for commercial clothes dryers and the fees for such permits shall be assessed as set forth from time to time by ordinance. No warm air heating and ventilation permit shall be required for domestic clothes dryers under 30,000 BTU/hr. or 9,000 watts.
(J) Warm air heating and ventilation permits for warm air heating devices with variable input burners shall be assessed on the maximum inputs of the device.
(K) Warm air heating and ventilation permits shall be required for incinerators and crematories and the fee for such permits shall be assessed as set forth from time to time by ordinance.
(L) Warm air heating and ventilation permits shall be required for solar warm air heating systems and the fees for such permits shall be based upon BTU's at 400 BTU per square feet of solar panel and shall be assessed as set forth from time to time by ordinance.
(M) Warm air heating and ventilation permits shall be required for retrofit automatic flue dampers on warm air heating devices and domestic hot water heaters and the fee for such permit shall be assessed as set forth from time to time by ordinance.
(N) Warm air heating and ventilating permits shall be required for wood or coal burning stoves connected to a central heating system and the fee for such permits shall be as set forth from time to time by ordinance.
(O) Warm air heating and ventilating permits shall be required for commercial kitchen hood and exhaust and the fee for such permits shall be as set forth from time to time by ordinance.
('80 Code, § 1333.09) (Ord. 76-80, passed 11-3-80; Am. Ord. 01-16, passed 2-8-16)
Editor's Note:
A copy of the most recent ordinance establishing current city fees and service charges is available at city offices during normal business hours.
(A) Permits shall be required as follows:
(1) Residential. Only one permit shall be required for each residential building regulated by the Dublin Residential Code.
(B) For the purpose of this section, environmental comfort systems shall include heating, air conditioning, humidification, air cleaning, ventilation devices and all ducts, outlets and inlets in each dwelling unit.
(D) Permit fees shall be assessed as follows: residential, each new and existing building, multiple-family dwelling - as set forth from time to time by ordinance.
('80 Code, § 1333.10) (Ord. 76-80, passed 11-3-80; Am. Ord. 01-16, passed 2-8-16) Penalty, see § 150.999
Editor's Note:
A copy of the most recent ordinance establishing current city fees and service charges is available at city offices during normal business hours.
(A) Refrigeration permits shall be required as follows:
(1) Only one refrigeration permit shall be required for each residential building regulated by the Dublin Residential Code.
(2) For all other buildings not included above, a separate refrigeration permit shall be required for each certified address.
(3) Whenever repair of environmental or product refrigeration systems necessitates replacement of component parts, a major component part shall be a non-hermetically sealed compressor, condenser, receiver, accumulator or evaporator.
(B) The minimum refrigeration permit shall be as set forth from time to time by ordinance.
(C) For all refrigeration permit calculations 12,000 BTU's shall be equal to one ton of refrigeration or one horsepower.
(D) Refrigeration permit fees shall be assessed as follows:
(1) Residential refrigeration, each new building - as set forth from time to time by ordinance.
(2) Nonresidential refrigeration, new and existing buildings - as set forth from time to time by ordinance.
Refrigeration systems shall include all condensing units, evaporators and refrigeration accessories; replacement of condensing units shall be assessed fees in accordance with this schedule and shall include the electrical inspection of the final connection, not to exceed five feet beyond equipment.
(E) Refrigeration permit fees for cooling towers shall be assessed as set forth from time to time by ordinance.
(F) Refrigeration permit fees for evaporative coolers shall be assessed as set forth from time to time by ordinance.
(G) Refrigeration permits for installation of product refrigeration shall be required as follows: Whenever repair of nonresidential environmental product refrigeration systems necessitates replacement of component parts, a major component part shall be a non-hermetically sealed compressor, condenser, receiver, accumulator or evaporator.
(H) Refrigeration permit fees for installation of product refrigeration systems shall be assessed as set forth from time to time by ordinance.
Refrigeration systems shall include all condensing units, evaporators and refrigeration accessories. The permit shall describe devices installed and capacities of each device and the fee shall be based on the total installed BTU/hour. One evaporator shall be included with each condensing unit listed as a device on the permit schedule. A fee as set forth from time to time by ordinance for each additional evaporator listed on the same permit shall be assessed. Heat reclamation coil in conjunction with refrigeration system shall be assessed a fee as set forth from time to time by ordinance.
(I) Refrigeration permit fees for alteration of environmental or product refrigeration systems shall be assessed according to the schedule for installation of such system.
(J) Refrigeration permit fees for repair of nonresidential environmental or product refrigeration systems shall be assessed as set forth from time to time by ordinance.
(K) Refrigeration permits shall be required for solar refrigeration systems and such permits shall be based on 400 BTU's per square foot of solar panel assessed according to schedule for installation of such systems set forth in division (D) above.
('80 Code, § 1333.11) (Ord. 76-80, passed 11-3-80; Am. Ord. 24-07, passed 5-21-07; Am. Ord. 01-16, passed 2-8-16) Penalty, see § 150.999
Editor's Note:
A copy of the most recent ordinance establishing current city fees and service charges is available at city offices during normal business hours.
(A) Steam and hot water permits shall be required, when not regulated by the Ohio Boiler and Pressure Vessel rules, Chapters 4101:4-1 to 4101:4-10 of the Ohio Administrative Code, as follows:
(1) Residential. Only one steam and hot water permit shall be required for each residential building regulated by the Dublin Residential Code.
(2) Nonresidential. For all other buildings not included above, a separate steam and hot water permit shall be required for each certified address.
(B) For any steam and hot water heating permit the minimum fee shall be as set forth from time to time by ordinance. Whenever modification of a steam or hot water boiler necessitates revision of the safety control sequence a minimum permit fee shall not be assessed.
(C) Steam and hot water heating permit fees for new and replacement boilers connected to a system shall be assessed as set forth from time to time by ordinance.
(D) Steam and hot water heating permit fees for heating fixtures or devices to be attached to steam or hot water boilers shall be assessed as set forth from time to time by ordinance.
(E) Steam and hot water heating permit fees for heating fixtures or devices described in division (D) above shall include, but are not limited to the following:
Unit vents Auditorium unit 300 sq. ft. radiant heat or
Cabinet unit heaters Domestic hot water fraction thereof
Ceiling radiators coil boiler Pressing machine
Ceiling radiators Water and steam coils Offset pressing machine
Console heaters Air compressors Puff-iron set
Cabinet heaters Solvent still Cleaning machine
300 sq. ft. snowmelting Vulcanizing machine Spot board
ovens 10 ft. 1 section Vacuum machine
Hot water unit blower baseboard radiation
(F) Steam and hot water heating permits shall be required for gas and oil domestic and commercial conversion burners on boilers and the fees for such permits shall be assessed as set forth from time to time by ordinance.
(G) Steam and hot water heating permits shall be required for dual-fuel burners where equipment is or has been existing on boilers but was installed and fired with one fuel on original permit. This permit shall be for installation and firing with the standby or second fuel and the fee for such permit shall be assessed as set forth from time to time by ordinance.
(H) Steam and hot water heating permits for boilers with variable input burners shall be assessed on the maximum inputs.
(I) Steam and hot water heating permits shall be required for stokers and the fees for such permits shall be assessed as set forth from time to time by ordinance.
(J) Steam and hot water heating permits shall be required for retrofit automatic flue dampers on boilers and the fee for such permits shall be assessed as set forth from time to time by ordinance.
(K) Steam and hot water heating permits shall be required for solar panels or systems connected to hot water heating systems and the fees for such permits shall be based upon BTU's at 400 BTU per square feet of solar panel and shall be assessed as set forth from time to time by ordinance.
('80 Code, § 1333.12) (Ord. 76-80, passed 11-3-80; Am. Ord. 01-16, passed 2-8-16) Penalty, see § 150.999
Editor's Note:
A copy of the most recent ordinance establishing current city fees and service charges is available at city offices during normal business hours.
Loading...