(A) General. All markers/monuments will be properly set flush with the ground and approved by a registered land surveyor prior to the time the Commission grants secondary approval to the plat.
(B) External boundaries.
(1) The applicant shall place monuments at the intersection of all lines forming angles in the boundary of the subdivision and at all intersections of street right-of-way lines and at the beginning and end of all curves along street right-of-way lines.
(2) Monuments shall be of an iron or steel solid bar at least 30 inches in length and not less than 5/8 of an inch in diameter, or of concrete with dimensions of four inches square or four inches in diameter at least 30 inches in length and marked with a cross, brass plug, iron rod or other durable material securely embedded so that the top of the dowel is flush with the top of the monument. Monuments shall be set following grading of each phase of the subdivision.
(C) Internal boundaries.
(1) The applicant shall place markers, unless otherwise located by a monument, at all points where lot lines intersect street right-of-way lines, at all angles in the lot property lines, and at all other lot comers.
(2) Markers shall be galvanized steel or wrought iron pipe or steel bars at least 5/8 of an inch in diameter and at least 24 inches in length. They shall be set prior to the issuance of any building permit.
(Ord. 5-2009, passed 3-9-09)