1248.03 SPATIAL REQUIREMENTS.

   (a)   All lots and buildings shall meet the minimum area and width requirements of Table 1248.03. New lots shall not be created, except in conformance with these requirements.

 

Table 1248.03 Lot and Width Requirements: Residential Districts
Zoning District	Minimum Lot Area (Sq. Ft.)1	Minimum Lot Width (Ft.)
R-A, Low-Density Residential	7,5002	60
R-B, Moderate-Density Residential	6,0003	50
R-C, High-Density Residential	4,8004	40
1   Public water and sanitary sewer is required for all property in these districts. 2   Two-family and attached single-family dwellings and multi-family dwellings are permitted a density up to 6 units per acre. 3   Two-family, attached single-family and multi-family dwellings are permitted a density up to 8 units per acre. 4   Two-family, attached single–family and multi-family dwellings are permitted a density up to 14 units per acre.

 

   (b)   All structures and their placement on a lot shall conform to the minimum dimensional requirements listed in Table 1248.03a.

Table 1248.03a Dimensional Requirements: Residential Districts
Zoning District	Maximum Building Height (Ft./stories)	Minimum Yard Setbacks (Ft.)				Max. Lot Coverage (%)
		Front	Side		Rear
			Total	Least
R-A	35/2.5	25	20	10	25	35
R-B	35/2.5	20	15	5	20	40
R-C	35/3	20	10	5	15	50
4   Average established setback shall apply, where applicable, in accordance with Section 1260.02(a). 5   A structure as measured from its furthest extension must be located outside the minimum setback areas.

 

(Ord. 2013-19. Passed 9-16-13; Ord. 2016-18. Passed 9-19-16; Ord. 2016-31. Passed 11-21-16; Ord. 2017-05. Passed 4-17-17; Ord. 2020-31. Passed 11-16-20; Ord. 2023- 18. Passed 5-1-23.)