(a) The preliminary plat shall conform with the Technical Design Standards as required.
(b) The preliminary plat shall contain the following information:
(1) Proposed name of the subdivision, which shall not duplicate or closely approximate the name of any other subdivision in the County.
(2) Location by section, range, and township.
(3) Names, addresses, and telephone numbers of the owner, subdivider, professional surveyor who prepared the plat and the name, address, and telephone number of the engineer who supplied the supplementary information.
(4) Date of survey.
(5) Scale of the plat, north point, and date.
(6) Boundaries of the subdivision and its acreage.
(7) Names of adjacent subdivisions, owners of record of adjoining parcels of unsubdivided land, and the location of their boundary lines.
(8) Locations, widths, and names of existing streets, railroad right-of-ways, easements, permanent buildings, and corporation and township lines; location of wooded areas and other significant natural items, soil types and soil limits, limits of Flood Hazard zones.
(9) Zoning classification of the tract and adjoining properties.
(10) Existing contours (USGS datum) at an interval of not greater than two (2) feet if the slope of the ground is fifteen percent (15%) or less; and not greater than five (5) feet where the slope is more than fifteen percent (15%).
(11) Existing sewers, water and gas mains, culverts and other underground structures, and electric and telephone poles and lines and other above ground structure within and adjacent to the tract.
(12) Layout, names and widths of proposed streets and easements.
(13) Building setback lines with dimensions.
(14) Layout and dimension of all proposed water and sewer lines, showing their connections with existing systems, and all proposed easements for utility, water, and sewer lines.
(15) Layout, numbers and approximate dimensions of each lot. When lots are located on a curve or when side lot lines are not at ninety (90) degree angles, the width at the building line shall be shown, if it is less than the frontage width. Location of access from the lots to the proposed streets shall be shown.
(16) Parcels of land to be reserved for public use or to be reserved by covenant for residents of the subdivision.
(17) The limits of all Flood Hazard Areas (zone A, AE, B, and X) as determined by the Federal Emergency Management Agency (show the FEMA map number and date). The Base Flood Elevation shall be determined and shown. Minimum first floor elevations shall be shown for all lots located within Flood Hazard Areas.
(Ord. 2021-17. Passed 9-8-21.)