(a) Uses permitted within the PUD-B: Uses permitted within the zoning district for which the project site is located.
(b) Permitted building and lot types: Building and lot types permitted within the zoning district for which the project site is located.
(c) Permitted accessory structures and uses: Accessory structures and uses permitted within the zoning district for which the project site is located.
(d) General requirements:
(1) At the time of application for a planned unit development, all land, structures, and other real property shall be in single or joint ownership of whatever form, or the petitioner shall have the right to acquire ownership under a valid option, and this information shall be included in the submission of an application for a planned unit development.
(2) The development shall be in full compliance with all density and lot coverage limitations and requirements of the zoning district in which the development is to be located.
(3) All new planned unit developments shall provide concrete sidewalks along both sides of all existing and proposed public streets within the PUD-B. Sidewalks shall only be required on the internal side of existing streets that are on the perimeter of the PUD-B. Sidewalks shall be a minimum of five (5) feet wide and four inches thick. Sidewalks will not be required along alleys. All pedestrian segments shall meet or exceed ADA standards and shall be constructed of concrete.
(4) The Town Council may require buffering around the proposed PUD-B.
(5) In approving an application for a PUD-B, the Town Council shall find that the proposed development will be compatible with comprehensive land use, and neighborhood development plans, will not place an excessive traffic load on local streets, that the site can be developed according to a site plan that will be compatible with existing neighborhood development, and that the site can be provided with adequate utility services.
(6) Site development within the PUD-B shall conform to the schematic plan, and associated requirements of the special use permit approved by the Town Council. Modification of the development plan may be made by the Town Council after their initial approval upon application by the owner of the property.
(7) Following approval by the Town Council of a PUD-B special use permit, the property for which approval was granted shall be labeled "PUD-B" on the official zoning map.
(e) Application requirements: An application for a special use permit to allow a PUD-B shall be accompanied by schematic plans showing the information listed below. Also, the Town Council may require additional information necessary to ensure compliance with the provisions of this chapter. For the purposes of this ordinance, no application shall be considered to have been submitted until it is complete.
(1) Proposed location of buildings and their general exterior dimensions;
(2) Proposed use of all the land within the area requested for a PUD-B;
(3) Dimensions between all buildings and from buildings to property lines;
(4) Traffic, parking, and circulation plan showing proposed locations and arrangement of parking spaces and ingress and egress to and from adjacent streets;
(5) Proposed location and material of any screening walls, fences, or plantings;
(6) Proposed exterior design of buildings;
(7) Schedule of number and size of dwelling units/buildings within the project;
(8) Proposed schedule and staging, if any, for the construction of the project. (Ord. of 1/10/05; Ord. of 12/6/10; Ord. of 6/28/21)