A. All areas of a lot to be used for the purposes of parking, loading, storage or access to any parking, loading or storage area shall be graded, surfaced, drained, and marked in accordance with all city standards and the provisions of this title. Parking stalls shall be clearly delineated by striping not less than three inches wide and appropriately labeled for loading, handicap parking, or other specified purpose, where necessary. Wheel stops and/or six-inch concrete curb shall be required for all parking stalls. Directional arrows and signs shall be placed on and off-site where required by the city engineer. In addition, parking area surfaces and grades shall comply with Section 20.70.080 of this title.
B. The following off-street parking standards shall apply to all new development. Parking shall be provided on a generalized land use basis, and the applicant shall demonstrate the adequate provision of spaces per individual land use.
Table 20.23-3 SP-23 Parking Requirements
Land Use | Required | Guest | Stall Size and Aisle Widths |
Single-family units | 1-3 BR: 2 garage spaces/unit 4-5 BR: 3 garage spaces | n/a | |
Townhome units | 1-3 BR: 2 garage spaces/unit 4-5 BR: 3 garage spaces | 1 space for every 4 units | |
Commercial, retail, office | 1 per 250 sq. ft. G.F.A. | n/a | |
Restaurants, bars, alcohol beverage manufacturing with tasting rooms | 1 per 100 sq. ft. G.F.A. | n/a | |
Brewery/distilling/ manufacturing | 1 per 1,000 sq. ft. G.F.A. | n/a | |
Outdoor dining area | 1 per 200 sq. ft. G.F.A. | n/a |
C. Calculations. All fractions resulting in 0.5 or greater are to be rounded up, all others rounded down, except in the case of guest parking in which case all fractions shall be rounded up to the next whole number.
D. Square Footage. Unless otherwise specified, square footage shall be based upon gross floor area of the building as defined in Section 20.04.300, which states that said floor area applies not only to the ground floor area, but also to any additional stories or basement of the structure. All horizontal dimensions shall be taken from the exterior faces of walls, including enclosed porches. Outdoor areas shall be measured to include all floor area required for seating.
(Ord. 2022-07-1537 § 4 (part), 2022)