§ 155.424 RESIDENTIAL TWO-FAMILY (R-2).
   (A)   Purpose. This district is intended primarily for attached, two-family residential dwelling neighborhoods with minimum lots per two-family dwelling units. Detached single-family dwelling units are permitted.
   (B)   Permitted uses. See Table 155.501.
   (C)   Dimensional Standards Table.
Table 155.424: Residential Two-Family (R-2)
Standard
Residential
Nonresidential
Table 155.424: Residential Two-Family (R-2)
Standard
Residential
Nonresidential
Minimum Lot Size
Width: 70 feet | Area: 7,000 square feet [1]
Width: 70 feet | Area: 7,000 square feet [1]
Maximum Lot Coverage
40%
40%
Maximum Height
Two stories or 30 feet
Two stories or 30 feet
Front Setback
25 feet
30 feet
Side Setback
7.5 feet [2]
20 feet [3]
Rear Setback
15 feet
25 feet
Street Side Setback
15 feet
15 feet
Minimum Floor Area
Single-Family Detached Dwelling: 750 square feet
N/A
Two-Family Attached Dwelling: 750 square feet per unit
Note(s):
[1]   If each half of a two-family dwelling is on separate adjoining lots then each lot shall not be less than 35 feet in width and 3,500 square feet in area.
[2]   However, if two-family dwelling is erected on two platted lots, no setback is needed along common wall and lot line.
[3]   Side setback shall increase by one foot for every two feet in height of structure or building exceeding 20 feet.
 
(Ord. 2021-02, adopted 3-17-21; sought to be reconsidered, Commission passed 4-21-2021)