925.06 REPORTING REQUIREMENTS.
   (a)   Baseline Monitoring Reports.
      (1)   Within either one hundred eighty (180) days after the effective date of a categorical Pretreatment Standard existing Categorical Industrial Users currently discharging to or scheduled to discharge to the POTW shall submit to the Board a report which contains the information listed in paragraph (a)(2), below. At least ninety (90) days prior to commencement of their discharge, New Sources, and sources that become Categorical Industrial Users subsequent to the promulgation of an applicable categorical Standard, shall submit to the Board a report which contains the information listed in paragraph B, below. A New Source shall report the method of pretreatment it intends to use to meet applicable categorical Standards. A New Source also shall give estimates of its anticipated flow and quantity of pollutants to be discharged.
      (2)   Users described above shall submit the information set forth below.
         A.   All information required in Section 925.04(e)(1)A.1., 925.04(e)(1)B. Section 925.04(e)(1)C.1. and Section 925.04(e)(1)F.
         B.   Measurement of pollutants.
            1.   The User shall provide the information required in Section 925.04(e)(1)G.1. through (4).
            2.   The User shall take a minimum of one representative sample to compile that data necessary to comply with the requirements of this paragraph.
            3.   Samples should be taken immediately downstream from pretreatment facilities if such exist or immediately downstream from the regulated process if no pretreatment exists.
            4.   Sampling and analysis shall be performed in accordance with Section 925.06(j);
            5.   The Board may allow the submission of a baseline report which utilizes only historical data so long as the data provides information sufficient to determine the need for industrial pretreatment measures;
            6.   The baseline report shall indicate the time, date and place of sampling and methods of analysis, and shall certify that such sampling and analysis is representative of normal work cycles and expected pollutant Discharges to the POTW.
         C.   Compliance Certification. A statement, reviewed by the User’s Authorized Representative as defined in Section 925.01(d)(3) and certified by a qualified professional, indicating whether Pretreatment Standards are being met on a consistent basis, and, if not, whether additional operation and maintenance (O&M) and/or additional pretreatment is required to meet the Pretreatment Standards and Requirements.
         D.   Compliance Schedule. If additional pretreatment and/or O&M will be required to meet the Pretreatment Standards, the shortest schedule by which the User will provide such additional pretreatment and/or O&M must be provided. The completion date in this schedule shall not be later than the compliance date established for the applicable Pretreatment Standard. A compliance schedule pursuant to this Section must meet the requirements set out in subsection (b) hereof.
         E.   Signature and Report Certification. All baseline monitoring reports must be certified in accordance with Section 925.06(m)(1) and signed by an Authorized Representative as defined in Section 925.01(d)(3).
   (b)   Compliance Schedule Progress Reports. The following conditions shall apply to the compliance schedule required by subsection (a)(2)D.:
      (1)   The schedule shall contain progress increments in the form of dates for the commencement and completion of major events leading to the construction and operation of additional pretreatment required for the User to meet the applicable Pretreatment Standards (such events include, but are not limited to, hiring an engineer, completing preliminary and final plans, executing contracts for major components, commencing and completing construction, and beginning and conducting routine operation);
      (2)   No increment referred to above shall exceed nine (9) months;
      (3)   The User shall submit a progress report to the Board no later than fourteen (14) days following each date in the schedule and the final date of compliance including, as a minimum, whether or not it complied with the increment of progress, the reason for any delay, and, if appropriate, the steps being taken by the User to return to the established schedule; and
      (4)   In no event shall more than nine (9) months elapse between such progress reports to the Board.
   (c)   Reports on Compliance with Categorical Pretreatment Standard Deadline. Within ninety (90) days following the date for final compliance with applicable categorical Pretreatment Standards, or in the case of a New Source following commencement of the introduction of wastewater into the POTW, any User subject to such Pretreatment Standards and Requirements shall submit to the Board a report containing the information described in Section 925.04(e)(1)F. and G. and subsection (a)(2)B. hereof. For Users subject to equivalent mass or concentration limits established in accordance with the procedures in Section 925.02(b) this report shall contain a reasonable measure of the User’s long-term production rate. For all other Users subject to categorical Pretreatment Standards expressed in terms of allowable pollutant discharge per unit of production (or other measure of operation), this report shall include the User’s actual production during the appropriate sampling period. All compliance reports must be signed and certified in accordance with subsection (m)(1). All sampling will be done in conformance with subsection (j) hereof.
   (d)   Periodic Compliance Reports.
      (1)   All Significant Industrial Users must, at a frequency determined by the Board submit no less than twice per year (June and December) reports indicating the nature, concentration of pollutants in the discharge which are limited by Pretreatment Standards and the measured or estimated average and maximum daily flows for the reporting period. In cases where the Pretreatment Standard requires compliance with a Best Management Practice (BMP) or pollution prevention alternative, the User must submit documentation required by the Board or the Pretreatment Standard necessary to determine the compliance status of the User.
      (2)   All periodic compliance reports must be signed and certified in accordance with subsection (m)(1) hereof.
      (3)   All wastewater samples must be representative of the User’s discharge. Wastewater monitoring and flow measurement facilities shall be properly operated, kept clean, and maintained in good working order at all times. The failure of a User to keep its monitoring facility in good working order shall not be grounds for the User to claim that sample results are unrepresentative of its discharge.
      (4)   If a User subject to the reporting requirement in this section monitors any regulated pollutant at the appropriate sampling location more frequently than required by the Board, using the procedures prescribed in subsection (j) hereof, the results of this monitoring shall be included in the report.
   (e)   Reports of Changed Conditions. Each User must notify the Board of any significant changes to the User’s operations or system which might alter the nature, quality, or volume of its wastewater at least fourteen (14) days before the change.
      (1)   The Board may require the User to submit such information as may be deemed necessary to evaluate the changed condition, including the submission of a wastewater discharge permit application under Section 1325.04(e).
      (2)   The Board may issue an individual wastewater discharge permit or modify an existing wastewater discharge permit under Section 1325.05(c) in response to changed conditions or anticipated changed conditions.
   (f)   Reports of Potential Problems.
      (1)   In the case of any discharge, including, but not limited to, accidental discharges, discharges of a nonroutine, episodic nature, a noncustomary batch discharge, a Slug Discharge or Slug Load, that might cause potential problems for the POTW, the User shall immediately telephone and notify the PUB of the incident. This notification shall include the location of the discharge, type of waste, concentration and volume, if known, and corrective actions taken by the User.
      (2)   Within five (5) days following such discharge, the User shall, unless waived by the PUB, submit a detailed written report describing the cause(s) of the discharge and the measures to be taken by the User to prevent similar future occurrences. Such notification shall not relieve the User of any expense, loss, damage, or other liability which might be incurred as a result of damage to the POTW, natural resources, or any other damage to person or property; nor shall such notification relieve the User of any fines, penalties, or other liability which may be imposed pursuant to this article.
      (3)   A notice shall be permanently posted on the User’s bulletin board or other prominent place advising employees who to call in the event of a discharge described in subsection (f)(1) above. Employers shall ensure that all employees, who could cause such a discharge to occur, are advised of the emergency notification procedure.
      (4)   Significant Industrial Users are required to notify the PUB immediately of any changes at its facility affecting the potential for a Slug Discharge.
   (g)   Reports from Unpermitted Users. All Users not required to obtain an individual wastewater discharge permit provide appropriate reports to the PUB as the PUB may require.
   (h)   Notice of Violation/Repeat Sampling and Reporting. If sampling performed by a User indicates a violation, the User must notify the PUB within twenty-four (24) hours of becoming aware of the violation. The User shall also repeat the sampling and analysis and submit the results of the repeat analysis to the PUB within thirty (30) days after becoming aware of the violation. Resampling by the Industrial User is not required if the PUB performs sampling at the User’s facility at least once a month, or if the PUB performs sampling at the User between the time when the initial sampling was conducted and the time when the User or the PUB receives the results of this sampling, or if the PUB has performed the sampling and analysis in lieu of the Industrial User.
   (i)   Analytical Requirements. All pollutant analyses, including sampling techniques, to be submitted as part of a wastewater discharge permit application or report shall be performed in accordance with the techniques prescribed in 40 CFR Part 136 and amendments thereto, unless otherwise specified in an applicable categorical Pretreatment Standard. If 40 CFR Part 136 does not contain sampling or analytical techniques for the pollutant in question, or where the EPA determines that the Part 136 sampling and analytical techniques are inappropriate for the pollutant in question, sampling and analyses shall be performed by using validated analytical methods or any other applicable sampling and analytical procedures, including procedures suggested by the PUB or other parties approved by EPA.
   (j)   Sample Collection. Samples collected to satisfy reporting requirements must be based on data obtained through appropriate sampling and analysis performed during the period covered by the report, based on data that is representative of conditions occurring during the reporting period.
      (1)   Except as indicated in subsection (j)(2) and (3) below, the User must collect wastewater samples using 24-hour flow-proportional composite sampling techniques, unless time-proportional composite sampling or grab sampling is authorized by the PUB. Where time-proportional composite sampling or grab sampling is authorized by the PUB the samples must be representative of the discharge. Using protocols (including appropriate preservation) specified in 40 CFR Part 136 and appropriate EPA guidance, multiple grab samples collected during a 24-hour period may be composited prior to the analysis as follows: for cyanide, total phenols, and sulfides the samples may be composited in the laboratory or in the field; for volatile organics and oil and grease, the samples may be composited in the laboratory. Composite samples for other parameters unaffected by the compositing procedures as documented in approved EPA methodologies may be authorized by the PUB, as appropriate. In addition, grab samples may be required to show compliance with Instantaneous Limits.
      (2)   Samples for oil and grease, temperature, pH, cyanide, total phenols, sulfides, and volatile organic compounds must be obtained using grab collection techniques.
      (3)   For sampling required in support of baseline monitoring and 90-day compliance reports a minimum of four (4) grab samples must be used for pH, cyanide, total phenols, oil and grease, sulfide and volatile organic compounds for facilities for which historical sampling data do not exist; for facilities for which historical sampling data are available, the PUB may authorize a lower minimum.
   (k)   Date of Receipt of Reports. Written reports will be deemed to have been submitted on the date postmarked. For reports, which are not mailed, postage prepaid, into a mail facility serviced by the United States Postal Service, the date of receipt of the report shall govern.
   (l)   Recordkeeping. Users subject to the reporting requirements of this article shall retain, and make available for inspection and copying, all records of information obtained pursuant to any monitoring activities required by this article, any additional records of information obtained pursuant to monitoring activities undertaken by the User independent of such requirements, and documentation associated with Best Management Practices established under Section 925.02(d)(3). Records shall include the date, exact place, method, and time of sampling, and the name of the person(s) taking the samples; the dates analyses were performed; who performed the analyses; the analytical techniques or methods used; and the results of such analyses. These records shall remain available for a period of at least three (3) years. This period shall be automatically extended for the duration of any litigation concerning the User or the PUB or where the User has been specifically notified of a longer retention period by the PUB.
   (m)   Certification Statements.
      (1)   Certification of Permit Applications, User Reports and Initial Monitoring Waiver. The following certification statement is required to be signed and submitted by Users submitting permit applications; Users submitting baseline monitoring reports under subsection (a)(2)E.; Users submitting reports on compliance with the categorical Pretreatment Standard deadlines under subsection (c) hereof; Users submitting periodic compliance reports required by subsection (d)(1)-(3), and Users submitting an initial request to forego sampling of a pollutant on the basis of subsection (d)(2)D. hereof. The following certification statement must be signed by an Authorized Representative as defined in Section 925.01(d)(3):
      I certify under penalty of law that this document and all attachments were prepared under my direction or supervision in accordance with a system designed to assure that qualified personnel properly gather and evaluate the information submitted. Based on my inquiry of the person or persons who manage the system, or those persons directly responsible for gathering the information, the information submitted is, to the best of my knowledge and belief, true, accurate, and complete. I am aware that there are significant penalties for submitting false information, including the possibility of fine and imprisonment for knowing violations.
      (2)   Annual Certification for Non-Significant Categorical Industrial Users. A facility determined to be a Non-Significant Categorical Industrial User by the PUB must annually submit the following certification statement signed in accordance with the signatory requirements in Section 925.01(d)(3). This certification must accompany an alternative report required by the PUB:
   Based on my inquiry of the person or persons directly responsible for managing compliance with the categorical Pretreatment Standards under 40 CFR ____, I certify that, to the best of my knowledge and belief that during the period from __________, ________ to ________, ________ [months, days, year]:
         (a)    The facility described as ____________________ [facility name] met the definition of a Non-Significant Categorical Industrial User as described in Section 925.01(d)(41)C.;
         (b)    The facility complied with all applicable Pretreatment Standards and requirements during this reporting period; and (c) the facility never discharged more than 100 gallons of total categorical wastewater on any given day during this reporting period.
This compliance certification is based on the following information.
 
__________________________________________________________
__________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________ __________________________________________________________
(Ord. 1394. Passed 6-14-11.)