Skip to code content (skip section selection)
Compare to:
Newport Overview
Newport, KY Code of Ordinances
CITY OF NEWPORT, KENTUCKY CODE OF ORDINANCES
PREFACE
ADOPTING ORDINANCE
TITLE I: GENERAL PROVISIONS
TITLE III: ADMINISTRATION
TITLE V: MISCELLANEOUS
TITLE VII: TRAFFIC CODE
TITLE IX: GENERAL REGULATIONS
TITLE XI: BUSINESS REGULATIONS
TITLE XIII: GENERAL OFFENSES
TITLE XV: LAND USAGE
TABLE OF SPECIAL ORDINANCES
PARALLEL REFERENCES
Loading...
SECTION 12.3 RESIDENTIAL ZONES:
   Fences and/or walls within the R-1, R-2, R-3, R-4, and R-5 Zones shall conform to the following requirements:
      1.   SECTION 12.0 and the requirements set forth below for residential uses only.
         a.   The use of Class 7 and/or Class 8 fences shall be prohibited on any residential property.
         b.   The use of Class 1, Class 3 and/or Class 5 fences shall be prohibited in any required front yard.
         c.   No fence located in a required front yard shall exceed thirty-six (36) inches in height.
         d.   No fence located in a required side or rear yard shall exceed eighty-four (84) inches in height.
         e.   For the purposes of these regulations, a fence located along any portion of a residential property abutting a public right-of-way (except along an "alley") shall not be greater than thirty-six (36) inches in height.
      2.   For all nonresidential uses permitted or conditional uses permitted herein:
         a.   SECTION 12.0, except that in front yards, Class 2 or 3 fences may be erected up to a maximum height of seventy-two (72) inches.
         b.   Side or rear yards, Class 1, 2, 3, 4, 5, 6, or 7 fences or walls may be erected up to a maximum height of ninety six (96) inches.
SECTION 12.4 COMMERCIAL ZONES:
   Fences and/or walls within the CBD, NC, RFD, CBDF, SC, and PO Zones, including those permitted with all conditionally permitted uses in these Zones, shall conform to the following requirements:
   A.   SECTION 12.0, except that in front yards of Zones SC, and PO, Class 2 or 3 fences may be erected up to a maximum height of seventy two (72) inches. In the CBD Zone, no fences or walls shall be permitted in the front yard.
   B.   Side and rear yard, class 1, 2, 3, 4, 5, 6, or 7, fences and/or walls, up to a height of seventy two (72) inches; except that Section 12.0 shall prevail at all intersections.
SECTION 12.5 INDUSTRIAL ZONES:
   Fences and/or walls within the I 1, and I 2 Zones shall conform to the following requirements:
   A.   Section 12.0, except that in front yards Class 2 or 3 fences, may be permitted up to a height of ninety six (96) inches.
   B.   Class 1, 2, 3, 4, 5, 6, or 7 fences and/or walls, up to a height of ninety six (96) inches; however, such maximum height may be required to be increased by the Zoning Administrator.
SECTION 12.6 MEASUREMENT OF ALL FENCE AND/OR WALL HEIGHTS AND/OR LOCATIONS:
   A.   All fences and/or wall heights shall be measured along the fence or wall locations.
   B.   All locations for distance measurements shall be measured from lot lines.
SECTION 12.7 HEIGHT OF ANY BARBED WIRE OR SHARP POINTED FENCES:
   A.   In zones, where permitted, barbed wire or sharp pointed fences shall not be less than a height of seventy two (72) inches.
   B.   Barbed wire or sharp pointed fences of any type shall not be permitted in any residential zone and where any zone abuts a residential zone said barbed wire shall be placed at least ninety-six (96) inches above the ground.
SECTION 12.8 HEIGHT OF FENCES ATOP RETAINING WALLS:
   A combination fence and retaining wall may be erected. The retaining wall portion may be erected up to the level of the higher finished grade. The fence portion must be of the class and height permitted within this Ordinance for the applicable zone. Said measurement shall be made at the location of the fence and retaining wall.
SECTION 12.9 FENCE CONSTRUCTION:
   A.   Construction of a fence shall occur with the supports facing inward on the property for which the permit is granted.
Loading...