(A) All metering locations and applica-tions shall be determined by an employee of Murray Electric System.
(B) Meter mounting height shall be measured from finished grade to center of meter. Meter mounting height shall be a maximum of six feet and a minimum of five feet unless special permission is granted by Murray Electric System.
(C) All meter bases on services rated 400 amps and below shall be provided by customer. All meter bases must be UL approved. All UDG installations must have factory-installed three-inch knock out.
(D) On installations exceeding 400 amps, Murray Electric System will provide all the metering equipment. Installation equipment shall be coordinated through Murray Electric System engineering department.
(E) A meter seal should never be broken by an individual without first obtaining permission of the Murray Electric System.
(F) No individual shall be authorized to disconnect or de-energize any electrical service except circuits on load side of meter.
(G) On overhead service, installations and maintenance of point of attachment, entrance and meter base shall be the responsibility of the customers although Murray Electric System maintains authority through the meter.
(H) At no time shall anyone connect any unmetered load. Any unmetered load connected to Murray Electric System shall be regarded as theft of services.
(I) Temporary unmetered tap ons for emergency construction purposes shall be supplied by Murray Electric System on a per-request basis. Any such tap-on shall be installed and removed by Murray Electric System personnel.
(Ord. 2001-1252, passed 8-23-01)