Access to a service station or other structure or parking lot shall be controlled as follows:
(a) Access shall be by not more than two roadways for each 100 feet or fraction thereof of frontage on any street;
(b) No two such roadways shall be closer to each other than twelve feet, and no roadway shall be closer to a side property line than three feet;
(c) Each roadway shall be not more than thirty-five feet in width, measured at right angles to the center line of the driveway, except as increased by permissible curb return radii. The entire flare of any return radius shall fall within the right of way.
(d) No roadway shall be closer than ten feet to the point of intersection of two property lines at any corner as measured along the property line, and no roadway shall extend across such extended property line.
(e) In all cases where there is an existing curb and gutter or sidewalk on the street, the applicant for a permit shall provide a safety island along the entire frontage of the property, except for the permitted roadways. On the two ends and street side of each island shall be constructed a concrete curb, the height, location and structural specifications of which shall be approved by the City Engineer. Maximum and minimum curb return radii permitted and minimum roadway approach angles to the center line of the street are required as shown on Figure 1 of the Appendix
, attached to this Zoning Code.
(f) Where there is no existing curb and gutter or sidewalk, the applicant may, at his option, install a safety island and curb, or, in place thereof shall construct along the entire length of the property line, except in front of the permitted roadways, a curb, fence or pipe rail not exceeding two feet or less than eight inches in height, as shown in Figure 2 of the Appendix
, attached to this Zoning Code.
(Ord. 4702. Passed 8-21-56.)
(Ord. 4702. Passed 8-21-56.)