(A) The construction of any parking lot shall be in accordance with the requirements of the provisions of this chapter and completed before a certificate of occupancy is issued.
(B) Unless incorporated in a site plan, prepared and approved in accordance with § 154.024, plans for the development of any parking lot must be submitted to the Zoning Administrator, prepared at a scale of not less than 50 feet equals one inch for submittal to the Planning Commission for approval. All information, including existing and proposed grades, drainage, pipe sizes, parking of all dimensions, type of curbing, drive and aisle dimensions, lighting, adjacent main buildings, sidewalks, landscaping, surfacing and base materials to be used, signage, use, building area, parking calculations and the layout of the proposed parking lot, and all other necessary information required by § 154.024, must be provided. All such parking lots, driveways, or loading areas required for uses other than single- or two-family residential shall be hard-surfaced with asphalt or concrete pavement. Drainage for parking lots shall conform to the standards set forth in § 154.120 and city design standards. All illumination for all such parking lots shall meet the standards set forth in § 154.117. Parking lot landscaping and buffering requirements shall meet the standards set forth in §§ 154.111(D) and 154.111(E). Adequate ingress and egress to the parking lot, by means of limited and clearly defined drives, shall be provided for all vehicles. To prevent encroaching upon pedestrian walkways or damaging required landscaping, curbing or other appropriate barriers shall be provided. No portion of a parking space and/or maneuvering aisle shall obstruct or encroach upon a pedestrian walkway. Plans for the layout of off-street parking facilities shall be in accordance with the following minimum regulations. (See Figure 13.)
Maneuvering Lane Width
| ||||
Parking Pattern
|
One-way | Two-way | Parking Space Width | Parking Space Length |
0 degrees - parallel | 12’ | 20’ | 9’ | 25’ |
30 degrees - 60 degrees | 12’ | N/A | 9’ | 18’ |
61 degrees - 89 degrees | 15’ | N/A | 9’ | 18’ |
90 degrees | N/A | 24’ | 9’ | 18’ |
(Ord. 285, passed 12-8-2003) Penalty, see § 154.999