(a) General Requirements. All research, investigation, monumentation, measurement specifications, plats of survey, descriptions, and subdivision plats shall conform to the Minimum Standards for Boundary Surveys in the State of Ohio, Section 4733-37 (Administrative Code) Ohio Revised Code. These standards are intended as a minimum requirement, and where the surveying profession requires or recommends a higher level of standards, the higher or most restrictive of such standards shall apply.
(b) Location. Monuments shall be placed at all angle points on the outside boundary of the subdivision. Iron pins shall be placed at all corners of all lots, intersections of the centerlines of the streets, and at the beginning and end points of each curved street section centerline. In those cases where sanitary sewer manholes prevent the setting of monuments, such monuments shall be offset five feet (5’) in each direction along the street centerline.
(c) When Set. Monuments in the street centerlines shall be placed upon the completion of paving of the streets. All other monuments are to be set upon completion of the street, water, sanitary sewer improvements, and over lot grading and before acceptance of improvements by the City of Lancaster.
(d) Materials. Monuments shall be constructed of concrete four inches (4”) in diameter and thirty inches (30”) long with a one inch (1”) diameter iron pin cast in the center. Iron pins shall be as per the standards cited above in Section 1109.13(a).
(e) Submittal. When required by the City Engineer, the Professional Surveyor shall submit a stamped drawing indicating the monument location along with such USGS or State Plane coordinates required for the County GIS System. Submittals shall be in the format determined by the City Engineer.
(Ord. 5-01. Passed 2-26-01.)
(Ord. 5-01. Passed 2-26-01.)