The final plat shall contain the following information:
(A) Name of the subdivision, location by section (or great lot), county and state;
(B) Date, north point and acreage;
(C) Name and address of the subdivider, the professional engineer who prepared the improvement plans, and the registered surveyor who prepared the plat and the appropriate registration numbers and seals;
(D) All plat boundaries, proposed lot lines, and bearings to half minutes; property lines of public open spaces and other sites with length of courses to 1/100 of a foot;
(E) Center lines of streets and rights-of-way of street, alleys, easements with accurate dimensions, bearings, or deflection angles and radii, arcs and central angles of all curves. Linear dimensions shall be expressed by bearings and distances in feet and hundredths thereof. All dimensions, both linear and angular, are to be determined by an accurate control survey in the field which must balance and close within the limit of the minimum standards of the R.C. § 4733.37;
(F) Names of existing and proposed streets or other rights-of-way;
(G) Location and purpose of easements;
(H) Number to identify each lot, site or block. All lots and blocks shall be numbered progressively;
(I) Dedication of streets, reserved areas, or other applicable areas within the boundaries of the plat;
(J) Excepted parcels or lots which shall be marked “Not Included in Plat” and the boundaries of which shall be completely described by courses and distances;
(K) Minimum building setback lines on all lots and other sites displayed graphically with dimensions from street lines;
(L) Accurate location and description of all monuments;
(M) Previous lots or blocks and their numbers indicated by relatively thinner lines (in the case of a replat);
(N) A copy of any restrictive covenants in form for recording shall be presented with the final plat to the Commission; and
(O) Flood hazard information of the area as required in § 151.155 of this chapter.
(Ord. 537, passed 7-19-90)