The final plat, as submitted to the Plan Commission, shall be in strict accordance with approved tentative plat and shall be drawn on tracing cloth or other approved materials to a scale of not less than one hundred feet to the inch (1" = 100'). Three (3) white prints of the final plat shall accompany the original tracing. The final plat shall show or otherwise satisfy the following requirements:
A. All items listed in Section 11-1-7 hereof, as required for the tentative plat, except such of said items specifically waived by the Plan Commission.
B. Certificate of licensed surveyor or engineer that property has been surveyed and the plat submitted is a correct presentation of the property as it is proposed to be divided or subdivided or dedicated and date of said certificate.
C. Certificate of owner or owners in a form satisfactory to the Plan Commission.
D. Proper certificates to provide for the approving signatures of the proper officers of the Plan Commission and the Village Board and for recording or registering signatures of the proper officials of DuPage or Cook Counties.
E. That all streets have been named in conformance with existing naming plan of the Village or other adjoining roads or streets where possible.
F. All lot lines shall be shown and all lots and blocks shall be numbered by progressive numbers.
G. Easements of any nature shall be shown and designated by measurements as to width and length.
H. Sufficient dimensions, both linear and angular, in accordance with standard surveying practice shall be shown, so as to permit retracement of any part of the subdivision in the future without difficulty including curve data and coordinates of boundary corners. Linear measurements shall be in feet and decimals thereof, and angular measurements in degrees and minutes. All curved lines in the subdivision shall have fixed radii which shall be indicated thereon and all starting and ending points of curved lines shall be suitably designated on the plat.
I. Evidence that suitable monuments, consisting of Portland cement concrete four and one-half inches by four and one-half inches by forty two inches (41/2" x 41/2" x 42") or approved equal have been installed at the direction of the enforcing officer. Iron pipes or monuments are required at block corners, at changes in direction of exterior boundaries, at angle points in street lines exclusive of block corners and such other points as the enforcing officer may direct. Iron pipe stakes shall not be less than three-quarters inch (3/4") in diameter and thirty inches (30") long and shall be installed at all corners and the beginning and ending of each fixed radius curve except where larger stakes are required as above. The use of wooden stakes to mark any of the above named points shall not be permitted. The surveyor or engineer shall indicate on the plat by suitable symbol the location and nature of all stakes or monuments in place.
J. That provision has been made for direct street or alley connections with existing public streets and alleys in adjacent and abutting areas or subdivisions that if extended would intersect this subdivision, unless specifically waived by the Plan Commission.
K. The owner's certificate specified in subsection C above shall contain a statement of dedication properly conveying for public use all streets, alleys, school sites, parks, playgrounds, easements or other public purpose.
L. Any other certificates, seals and signatures or dates not enumerated herein as required by law.
M. Legal description of property.