(A) The owner of any property serviced by a building sewer carrying industrial wastes shall provide laboratory measurements, tests and analyses of waters and wastes to illustrate compliance with this chapter and any special conditions for discharge established by the village or regulatory agencies having jurisdiction over the discharge. The number, type and frequency of laboratory analyses to be performed by the owner shall be as stipulated by the village, but no less than once per year the industry must supply a complete analysis of the constituents of the wastewater discharge to assure that compliance with the federal, state and local standards is being met. The owner shall report the results of measurements and laboratory analyses to the village at such times and in such manner as prescribed by the village. The owner shall bear the expense of all measurements, analyses and reporting required by the village. At those times as deemed necessary, the village reserves the right to take measurements and samples for analysis by an outside laboratory service.
(B) All measurements, tests and analyses of the characteristics of waters and wastes to which reference is made in this chapter shall be determined in accordance with the latest edition of Standard Methods for the Examination of Water and Wastewater, published by the American Public Health Association, and shall be determined at the control manhole provided, or upon suitable samples taken at the control manhole. In the event that no special manhole has been required, the control manhole shall be considered to be the nearest downstream manhole in the public sewer to the point at which the building sewer is connected. Sampling shall be carried out by customarily accepted methods to reflect the effect of constituents upon the sewage works and to determine the existence of hazards to life, limb and property. The particular analyses involved will determine whether a 24-hour composite of all outfalls of a premises is appropriate or whether a grab sample or samples should be taken. Normally, but not always, B.O.D. and suspended solids analyses are obtained from 24-hour composites of all outfalls, whereas pH is determined from periodic grab samples.
Penalty, see § 50.99