Industrial Light districts provide for a mix of light manufacturing, office park, flex space, and limited retail and service uses that ser- vice the industrial uses with proper screening and buffering-all compatible with adjoining uses.
(b) Dimensional Standards. The dimensional standards within the "IL" (Industrial Light) district are outlined in Table 1103-10 (see Figure 1103-7).
(c) General Provisions. Uses in the "IL" (Industrial Light) district shall comply with the following and other applicable sections of this chapter:
(1) Principal vehicle access to and from the site shall be from a primary driveway.
(2) All loading shall be from the rear or side of the building and shall be completely screened from view at the street. These loading standards apply to new structures only, and existing buildings with loading docks facing the street may continue to be used, restored, or enlarged without being subject to the side or rear loading requirement of this section. Loading docks may be located in the rear yard, or a side yard facing a street that is internal to an "IL" (Industrial Light) or "IH" (Industrial Heavy) zoning district.
(d) Building Design. Building design shall conform to the appropriate building type design standards (Section 1105.27 Building Design).
Zoning District | "IL" |
Lot size (minimum, square feet) | - |
Density (maximum, dwelling units per gross acre) | - |
Frontage (minimum, feet) | 50 |
Lot width (minimum, feet) | 50 |
Lot width (maximum, feet) | - |
Height (maximum, feet) | 50 |
Stories (maximum) | 5 |
Front setback (minimum, feet) | 20 |
Maximum front setback (maximum, feet) | - |
Side setback (minimum, feet) | 20 |
Rear setback (minimum, feet) | 30 |
Lot coverage (maximum, percent) | 70 |
Minimum frontage built-out (percent) | - |
A dash ("-") means "not applicable."
(Ord. 32-2020. Passed 1-19-21.)