Skip to code content (skip section selection)
Compare to:
§ 12.5-610.2 DISCHARGES TO THE TRINITY RIVER AUTHORITY DENTON CREEK WASTEWATER TREATMENT FACILITY.
   (a)   General prohibitions. No user shall introduce or cause to be introduced into the POTW any pollutant or wastewater which causes pass through or interference. These general prohibitions apply to all users of the POTW regardless of whether they are subject to categorical pretreatment standards or any other national, state or local pretreatment standards or requirements.
   (b)   Specific prohibitions. No user shall introduce or cause to be introduced into the POTW the following pollutants, substances or wastewater:
      (1)   Pollutants which create a fire or explosive hazard in the POTW, including, but not limited to, waste streams with a closed-cup flashpoint of less than 140°F (60°C) using the test methods specified in 40 C.F.R. § 261.21;
      (2)   Wastewater having a pH less than 6.0 or more than 10.0, or otherwise causing corrosive or structural damage to the POTW or equipment;
      (3)   Solid or viscous substances in amounts which will cause obstruction of the flow in the POTW resulting in interference but in no case solids greater than one-half inch in any dimension or fats, oil and grease measured as total oil and grease in excess of 100 mg/l;
      (4)   Pollutants, including oxygen-demanding pollutants (BOD, etc.), released in a discharge at a flow rate and/or pollutant concentration which, either singly or by interaction with other pollutants, will cause interference with the POTW; biochemical oxygen demand (five-day) in excess of 250 mg/l surcharge limit only), total suspended solids in excess of 250 mg/l (surcharge limit only).
      (5)   Wastewater having a temperature greater than 150°F (65°C), or which will inhibit biological activity in the treatment plant resulting in interference, but in no case wastewater which causes the temperature at the introduction into the treatment plant to exceed 104°F (40°C);
      (6)   Petroleum oil, nonbiodegradable cutting oil or products of mineral oil origin, in amounts that will cause interference or pass through;
      (7)   Pollutants which result in the presence of toxic gases, vapors or fumes within the POTW in a quantity that may cause acute worker health and safety problems;
      (8)   Trucked or hauled waste except at discharge points designated by the director;
      (9)   Noxious or malodorous liquids, gases, solids or other wastewater which, either singly or by interaction with other wastes, are sufficient to create a public nuisance or a hazard to life, or to prevent entry into the sewers for maintenance or repair; hydrogen sulfide, sulfur dioxide or nitrous oxide in excess of ten one-hundredths mg/l;
      (10)   Wastewater which imparts color which cannot be removed by the treatment process, such as, but not limited to, dye wastes and vegetable tanning solutions;
      (11)   Wastewater containing any radioactive wastes or isotopes except in compliance with applicable state or federal regulations;
      (12)   Stormwater, surface water, ground water, artesian well water, roof runoff, subsurface drainage, condensate, deionized water, noncontact cooling water and unpolluted wastewater, unless specifically authorized by the director;
      (13)   Sludges, screenings or other residues from the pretreatment of industrial wastes;
      (14)   Medical wastes, except as specifically authorized by the director in a wastewater discharge permit;
      (15)   Wastewater causing, alone or in conjunction with other sources, the treatment plant’s effluent to fail a toxicity test; total toxic organics in excess of one mg/l collected as a grab sample.
      (16)   Detergents, surface-active agents or other substances which may cause excessive foaming in the POTW; or
      (17)   Swimming pool drainage from private residential pools. Swimming pool drainage from public and semi-public swimming pools may be discharged to the POTW with the prior consent of the director. Swimming pool filter backwash may be discharged to the POTW.
   (c)   Categorical pretreatment. The categorical pretreatment standards found at 40 C.F.R. Chapter I, Subchapter N, Parts 405-471 are hereby incorporated into this article. A user shall not discharge in violation of categorical pretreatment standards.
      (1)   Where a categorical pretreatment standard is expressed only in terms of either the mass or the concentration of a pollutant in wastewater, the director may impose equivalent concentration or mass limits in accordance with 40 C.F.R. § 403.6(c).
      (2)   When regulated, process wastewater subject to a categorical pretreatment standard is mixed with non-regulated wastewaters prior to treatment, the director or the industrial user with the written concurrence of the director, shall derive fixed alternative discharge limits in accordance with procedures and the combined wastestream formula found in 40 C.F.R. § 403.6(e) or by a flow weighted average.
      (3)   A user may obtain a variance from a categorical pretreatment standard if the user can prove, pursuant to the procedural and substantive provisions in 40 C.F.R. § 403.13, that factors relating to its discharge are fundamentally different from the factors considered by the EPA when developing the categorical pretreatment standard.
      (4)   A user may obtain a net gross adjustment to a categorical standard in accordance with 40 C.F.R. § 403.15.
   (d)   Local limits.
      (1)   The following local pollutant limits are established to protect against pass through and interference. The limits apply at the point where the wastewater is discharged to the POTW. The director may impose mass limitations in addition to, or in place of, the concentration-based limitations. All concentrations for metallic substances are for total metal unless indicated otherwise.
      (2)   No person shall discharge wastewater containing the following. Pollutants in the form of compounds or elements with total concentrations exceeding the following:
Pollutant
Instantaneous Maximum Allowable Discharge Limit mg/l
Pollutant
Instantaneous Maximum Allowable Discharge Limit mg/l
Arsenic
0.1
Barium
1.0
Cadmium
0.1
Chromium
1.0
Copper
1.5
Lead
1
Mercury
0.005
Nickel
1.0
Selenium
.05
Silver
0.1
Zinc
2.0
Cyanide or cyanogen compounds (expressed as total CN-)
1.0
 
   (e)   The director may develop best management practices by ordinance approved by the city council, or in individual wastewater discharge permits to help implement local limits and other pretreatment standards and the requirements of this section.
   (f)   A person commits an offense if with criminal negligence the person processes or stores pollutants, substances or wastewater prohibited by this section in such a manner that they could be discharged to the POTW.
(Ord. 15496, § 8, passed 3-25-2003; Ord. 17074, § 7, passed 7-25-2006; Ord. 20043-01-2012, § 6, passed 1-10-2012)