A. The final plat shall be neatly drawn in ink on tracing cloth or reproducible mylar at a scale of at least one hundred feet (100') to the inch from an accurate survey and shall comply with the following format: (Res. 901, 5-10-1977)
1. The final plat shall be prepared on sheets whose dimensions are twenty four by thirty six inches (24 x 36"). The plat shall have a left side margin of two inches (2"); right side margin of not less than one inch (1"); and top and bottom margins of not less than one and one-half inches (11/2"). On the first sheet of every plat there shall be a map showing the location of the subdivision referenced to government survey section lines and major streets. If more than two (2) sheets are required for the plat, the key map shall show the number of the sheet for each area. (Res. 901, 5-10-1977; amd. 2015 Code)
B. The final plat shall bear the following information:
1. The location and description of all section corners and permanent survey monuments in or near the tract, to at least one of which the subdivision shall be referenced;
2. The length of all required lines dimensioned in feet and decimals thereof and the value of all required true bearings and angles dimensioned in degrees and minutes as hereafter specified;
3. The boundary lines of the land being subdivided fully dimensioned by lengths and bearings, the location of boundary lines of adjoining lands and adjacent subdivisions identified by official names. Material which is not a part of the subdivision shall be shown in dashed or dotted lines;
4. The lines of all proposed streets fully dimensioned by lengths and bearings or angles;
5. The lines of all proposed alleys. Where the length or direction of an alley is not readily discernible from data given for lot and block lines, the length or bearing shall be given;
6. The widths, and names where appropriate, of all proposed streets and alleys, and of all adjacent streets, alleys and easements which shall be properly located;
7. The lines of all proposed lots fully dimensioned by lengths and bearings or angles; except where a lot line meets a street line at right angles, the angle or bearing value be omitted;
8. The outline of any property which is offered for dedication to public use fully dimensioned by lengths and bearings, with the area marked "Public";
9. The blocks numbered consecutively throughout the entire subdivision, the lots numbered consecutively throughout each block and with areas to be excluded from platting marked "Reserved" or "Not a Part";
10. The location of all building lines, setback lines, and easements for public services or utilities with dimensions showing their locations;
11. The radii, arcs, points of tangency, points of intersection and central angles for curvilinear streets and radii for all property returns;
12. The proper acknowledgments of owners and the consent of the mortgagee to plat restrictions;
13. The following, which shall be made and shown on the cloth tracing:
a. Owner's certificate and dedication, signed;
b. Surveyor's certificate of survey, signed and his seal;
c. Certificate for release of mortgage for any portion dedicated to the public, signed;
d. Reference to any separate instruments, including restrictive covenants, filed in the office of the county recorder of deeds which directly affect the land being subdivided;
e. Certificate of planning commission approval;
f. Certificate of city council or board acceptance of ways, easements and public land dedications;
g. Treasurer's certificate; and
h. Certificate of health department approval where sanitary sewers are not proposed, signed;
14. A title which shall include:
a. Name of the subdivision;
b. Name of city, county and state; and
c. Location and description of the subdivision referenced to section, range and township. (Res. 901, 5-10-1977)