1119.11 BOUNDARY SURVEYS.
        (a)    General Standards. The "Minimum Standards for Boundary Surveys", set forth in Chapters 4733 to 4737 of the Ohio Administration Code, shall apply if not specifically superseded herein.
        (b)    Exterior Boundary Traverse. A complete boundary survey of the parcel being subdivided shall be made by a registered Ohio surveyor. The traverse shall close within a limit of error of one foot to 10,000 feet of the perimeter before balancing the survey.
        (c)    Monuments.
       (1)   A monument made of concrete or other material approved by the City Engineer, meeting the following minimum conditions, shall be installed at each corner or bend in the exterior boundary traverse:
         A.   Length: thirty inches
         B.   Diameter: four inches
         C.   A steel rod (one-half inch in diameter), running the full length of the monument in the center of the monument.
         D.   A durable marker bearing the surveyor's registration number and/or name or company name.
      (2)   Each new lot corner not receiving a concrete monument shall be pinned using either a solid steel pin with a minimum one-half inch diameter or a three-quarter inch steel pipe, along with a durable marker bearing the surveyor's registration number and/or name or company name. The minimum length for the pins is thirty inches.
      (3)   Curves in either the exterior boundary survey or new lots shall have the PC (point of curvature) and the PT (point of tangency) either monumented or pinned as appropriate.