§ 17.210.025 SUPPLEMENTAL STANDARDS FOR TOWNHOUSE DEVELOPMENTS.
This section provides development standards specific to townhouse developments which are permitted in RLD, RMD, and all mixed use zoning districts. Townhouses shall conform to the requirements in Table 2-5. These standards are in addition to and supersede the base standards for the RLD, RMD, and all mixed use zoning districts, except where there is a conflict, in which case the standards in Table 2-5 supersede those in Table 2-4, Table 2-7, and Table 2-8.
   Table 2-5 Supplemental Standards for Townhouse Developments
TOWNHOUSE DEVELOPMENT STANDARDS
STANDARD
Additional Regulations
TOWNHOUSE DEVELOPMENT STANDARDS
STANDARD
Additional Regulations
Lot and Density Standards
Minimum net lot size per dwelling unit (for new lots)
900 square feet
 
Minimum lot width per dwelling unit (for new lots)
20 feet; 30 feet for corner and reverse corner lots
Attached Single-Family Homes/Townhouses: A minimum lot width of 30 to 40 feet may be necessary for townhouses with double loaded attached garages in front, and to comply with parking location and design requirements. Minimum lot width may be reduced to 20 feet if garages are single-car wide, detached and/or accessed from an alley.
Lot Setbacks - Minimum (feet)
Front
5 feet
 
Street side (corner lots)
5 feet
 
Interior side when abutting a townhouse within the same townhouse development
0 feet
 
Interior side when containing an end unit
5 feet
 
Rear
10 feet
 
Alley (when present)
5 feet
 
Garage/Surface Parking Frontage
Maximum parking frontage on a public street (for new residential development)
NA
 
Open Space
Maximum front yard paving
NA
Any area that is not a driveway or walkway shall be landscaped.
Minimum required landscaping
Refer to Chapter 17.310 (Landscaping)
 
 
(Ord. No. 2024-006)