(a) Lot and Building Requirements. The following lot and building requirements are minimum standards, except where noted, and shall apply in the Limited Manufacturing District (LM):
(1) Lot area: No minimum lot area is required, however, all lots shall abut an improved public right-of-way and lot area shall be adequate to provide the required yard space.
(2) Lot coverage (maximum): No maximum lot coverage is required, however, the lot coverage shall be adequate to provide the yard space required.
(3) Lot width: No minimum lot width is required, however, all lots shall abut an improved public right-of-way and have adequate width to provide the required yard space and meet minimum access requirements.
(4) Front yard setback: The minimum front yard setback shall be no less than 50 feet measured from the street right-of-way.
(5) Side yard setback: For accessory structures, including open service and loading areas, the required side yards shall not be less than ten feet, unless adjacent to any residential zoning district, Planned Residential District, Planned Conservation District, Traditional Neighborhood Development District, and Planned Unit District whereby the side yard shall be no less than 50 feet. For main structures, including open service and loading areas, the required side yards shall not be less than 20 feet, unless adjacent to any residential zoning district, Planned Residential District, Planned Conservation District, Traditional Neighborhood Development District, and Planned Unit District whereby the side yard shall be no less than 50 feet. For purposes of this division, "main" shall be synonymous with "principal" as used elsewhere in the Zoning Code.
(6) Rear yard setback: For main and accessory structures the required rear yard shall be not less than 20 feet, unless adjacent to any residential zoning district, Planned Residential District, Planned Conservation District, Traditional Neighborhood Development District, and Planned Unit District whereby the rear yard shall be no less than 50 feet.
(b) Supplemental Standards. The following supplemental standards shall apply within the Limited Manufacturing District (LM):
(1) No building shall exceed 60 feet in height.
(2) Applicable standards shall be met in corresponding chapters of this Zoning Code.
(Ord. 2020-10, passed 6-15-2020; Am. Ord. 2022-06, passed 1-24-2022)