(A) Purpose. The purposes of the
Overlay Zone are to: promote flexibility in design and permit planned diversification in the relationships between location of and types of uses and
; promote the advantages of modern large scale site planning for community development through the efficient use of land, facilitating a more economic arrangement of buildings, circulation systems, land uses, and utilities; preserve, to the greatest extent possible, the existing landscape features and amenities, and to utilize such features in a harmonious fashion; provide for more usable and suitably located
facilities, other public and common facilities than would otherwise be provided under conventional land development procedures, but always with the intention of furthering the public health, safety, and general welfare.
(B) General. A
Overlay Zone may be permitted only to be superimposed over any of the Residential (R) Zones, provided that all conditions or provisions of this section of the chapter, the applicable requirements of the
regulations, and any additional requirements as may be determined necessary to provide for the most efficient layout of the PUD and its proper integration with the surrounding developments are met; and a public hearing is held on the PUD application.
(C) Application and processing. Application for
Overlay Zone shall be processed as follows in two stages:
(1) Stage I Development plan and zoning map amendment. Application for amendment to PUD Overlay Zone shall include a development plan in accordance with the requirements of division (D).
(a) The
shall hold a public hearing on the proposed application, in accordance with the requirements of KRS Chapter 424, and review said application with regard to its compliance with the stated purposes of the PUD Overlay Zone, the required elements of the Stage I development plan and other applicable requirements of this section. Upon holding such hearing the
shall make one of the following recommendations to the legislative body: approval, approval with conditions or disapproval. The
shall submit along with their recommendations a copy of the Stage I development plan and the bases for their recommendation.
(b) 1. The legislative body shall, within 45 days after receiving the recommendations of the
, review said recommendations and take action to approve, or disapprove said PUD application. Such action may incorporate any conditions imposed by the legislative body. However, should the legislative body take action to impose different conditions than were reviewed and considered by the
, then said conditions shall be resubmitted to the
, for further review and recommendation in accordance with division (C)(1)(a) of this section. Approval of the PUD Overlay Zone shall require that development be in conformance with the Stage I approval development plan.
2. The legislative body shall forward a copy of the approved development plan, certified as such by said body, to the
for further processing in accordance with the requirements for Stage II development plan and record plat.
3. Zoning map amendment. Upon approval of the PUD Overlay Zone, the official zoning map shall be amended by adding the prefix "PUD" to the existing Residential (R-1) Zone (for example, PUD-R-1B, PUD-R-1C, and the like) for the area as shown on the Stage I approved development plan.
(2) Stage II Development plan and record plat. A Stage II development plan and record plat shall be developed in conformity with the Stage I approved development plan and in accordance with the requirements of division (E) of this section, and submitted to the
for its review and approval. Except for the manner of submission and processing, the
regulations may be waived, where applicable, and the requirements of division (E) of this section shall be substituted therefor. Those requirements not specifically waived by the
shall conform with the
regulations.
(a) 1. The
shall review the submitted Stage II development plan with regard to its compliance with the required elements of division (E)(1) of this section, for Stage II development plans, other applicable elements of this chapter, other applicable regulations, and its conformity with the Stage I approved development plan. The
, in approving the Stage II development plan, may authorize minor adjustments from the Stage I approved development plan, provided that the adjustments do not: affect the spacial relationship of
, change land uses, increase overall density, alter circulation patterns (vehicular and pedestrian) or decrease the amount and/or usability of open space or
areas or affect other applicable requirements of this chapter.
2. Upon
approval of the Stage II development plan, copy of said plan shall be forwarded to the local
, who shall grant permits only in accordance with the Stage II approved development plan and other plans as may be required by this chapter.
(b) 1. Upon approval of the Stage II development plan, the
shall review the submitted record plat with regard to its compliance with the required elements of division (E)(2), for record plats, the applicable requirements of the
regulations, and its conformity with the Stage II approved development plan.
2. Upon
approval of the record plat, copies of said plat, certified by the
, and suitable for recording, shall be forwarded by the
to the office of the County Clerk to be recorded.
(D) Stage I Development plan requirements. The Stage I development plan shall identify and provide the following information:
(1) Plans of the subject property drawn to a scale not smaller than one inch equals 200 feet showing:
(a) The total area in the project by aerial photograph.
(b) The present zoning of the subject property and all adjacent properties.
(c) All public and private rights-of- way and
lines located on or adjacent to the subject property which are proposed to be continued, created, enlarged, relocated, or abandoned.
(d) Existing and proposed topography shown by contour with intervals not to exceed five feet.
(e) All existing and proposed housing units on the subject property:
1. Detached housing: Location, arrangement, and number of all
, including a typical section identifying approximate
sizes and dimensions, and setbacks and height of buildings.
2. Attached housing: Location, height, and arrangement of all buildings, number of units within each
, and all
lines with approximate dimensions where applicable.
(f) Location, arrangement, height, and identification of all existing and proposed nonresidential buildings and uses on the subject property.
(g) The amount of area proposed for common open space, including the location and arrangement of recreational facilities, identification of unique natural features to be retained and a statement indicating the means of maintaining all common areas.
(h) Location of proposed pedestrian walkways, identifying type of surfacing and approximate dimensions.
(i) Location of proposed streets identifying approximate dimensions of pavement and right-of-way widths, type of surfacing and approximate grades.
(j) Location of off-street parking, loading and/or unloading and driveway areas, identifying the number of off-street parking spaces to be provided, type of surfacing and approximate dimensions.
(k) Location of all existing and proposed water, sanitary sewer and storm drainage lines, indicating approximate pipe sizes and grades. Indication should also be given regarding the provision of electric and telephone service which shall be required to be installed underground.
(E) Stage II Development plan and record plat requirements. The Stage II development plan and record plat shall conform to the following requirements:
(l) Stage II Development plan.
(a) The applicant shall submit a Stage II development plan, in conformance with the Stage I approved development plan, at a scale not smaller than one inch equals 50 feet, that identifies and provides the following information:
l. The existing proposed finished topography of the subject property shown by contours with intervals not to exceed five feet. Where conditions exist that may require more detailed information on the proposed topography, contours with intervals of less than five feet may be required by the
.
2. All housing units on the subject property.
a. Detached housing: Location, arrangement, and number of all
, including exact
dimensions and setbacks, and maximum height of buildings;
b. Attached housing: Location, height, and arrangement of all buildings indicating the number of units in each
, and, where applicable, location and arrangement of all
with exact
dimensions.
3. Location, height, arrangement, and identification of all nonresidential buildings and uses on the subject property and, where applicable, location and arrangement of all
with exact
dimensions.
4. All common open space areas, including accurate
dimensions and the location and arrangement of all recreational facilities.
5. Landscaping features, including identification of planting areas and the location, type, and height of walls and
.
6. Location of
indicating their orientation and size and height.
7. All utility lines and easements:
a. Water distribution systems including line sizes, width of easements, type of pipe, location of hydrants and valves, and other appurtenances.
b. Sanitary sewer system, including pipe sizes, width of easements gradients, type of pipes, invert elevations, location and type of manholes, the location, type, size of all lift or pumping stations, capacity, and process of any necessary treatment facilities, and other appurtenances.
c. Storm sewer and natural draining system, including pipe and culvert sizes, gradients, location of open drainage courses, width of easements, location and size of inlets and catch basins, location and size of retention and/or sedimentation basins, and data indicating the quantity of storm water entering the subject property naturally, from areas outside the property, the quantity of flow at each pickup point (inlet), the quantity of storm water generated by development of the subject area, and the quantity of storm water to be discharged at various points to areas outside the subject property.
d. Other utilities (for example, electric, telephone, and the like) including the type of service and the width of easements, revealing the underground installation of the wiring.
8. Location of all off-street parking, loading and/or unloading, and driveway areas, including typical cross sections, the type of surfacing, dimensions, and the number and arrangement of off-street parking, and loading and/or unloading spaces.
9. Circulation system:
a. Pedestrian walkways, including alignment, grades, type of surfacing and width.
b. Streets, including
alignment, grades, type of surfacing, width of pavement and right-of-way, geometric details, and typical cross sections.
10. Provisions for control of erosion, hillside slippage, and sedimentation, indicating the temporary and permanent control practices and measures which will be implemented during all phases of clearing, grading, and construction.
11. The schedule of development staging and phasing in accordance with the requirement in division (D) (3) of this section, and as approved in the Stage I approved development plan.
(b) The information required by division (E) (1) (a) 1. through 11. of this section may be combined in any suitable and convenient manner so long as the data required is clearly indicated.
(2) Record plat. The applicant shall submit a record plat, in conformance with the Stage II approved development plan, at a scale not smaller than one inch equals 50 feet. If the record plat is submitted in sections, an index shall be developed showing the entire PUD. The particular number of the section, and the relationship of each adjoining section shall be clearly shown by a small key map on each section submitted. The record plat shall conform to the applicable requirements of the
regulations, unless specifically waived by the
, and in addition thereto, the following:
(a) All areas reserved for common ownership with an indication of the properties the owners will share in common.
(b) Such
or parcel lines indicating tracts which are now in separate ownership or which may be transferred to other ownership during or after development. (Resubdivision of large
containing several buildings may be accomplished at a later date upon application and approval of the
.)
(c) Indication of areas to be developed for residential (by type of housing unit), commercial, public, and semi-public uses.
(F) Residential uses and densities. All types of residential housing units (attached and detached) may be permitted within a PUD Overlay Zone, including single-family, two-family, and multi-family units. The density of
in a PUD shall be determined by the density (
per acre) as calculated from the existing Residential (R) Zone superimposed by the PUD Overlay Zone. This density shall be applied to the total project area excluding that land devoted to commercial uses and streets (
and
). Not more than 60% of the total acreage shall be utilized.
(G) Commercial uses.
(1) Commercial uses intended primarily for the service and convenience of residents of the PUD may be permitted within the project area provided a market analysis is made justifying the need for said uses.
(2) The commercial uses shall be grouped in complexes clearly delineated on the Stage I development plan, and may include one or more of the following uses:
(a) Delicatessen, grocery, meat, fruit, or vegetable market
(b) Drug store
(c) Bakery shop
(d) Laundry/dry cleaning, pick-up stations, or self-service facility
(e) Beauty or barber shop
(f) Shoe repair shop
(g) Hardware store
(h) Business or professional office
(i) Clothing store
(j) Restaurant
(k) Bank
(l) Theater
(3) Another use may be substituted on the Stage I approved development plan for a use previously approved providing it is one of the above listed uses and providing said use will not involve any
expansion beyond that approved in the Stage I approved development plan and further providing that said use is approved by the
, who will obtain the approval of the
, in writing.
(H) Public and semi-public uses. Public and semi-public
and uses may be permitted in the PUD. These uses shall be delineated on the Stage I development plan and shall be limited to one or more of the following uses:
(1) Schools (
, elementary, and secondary).
(2) Churches (parish houses included).
(3) Community centers, including day care facilities.
(4) Country clubs.
(5) Libraries.
(6) Fire and police stations.
(7) Open space,
areas.
(I) Area requirements. No PUD Overlay Zone shall be permitted on less than 25 acres of land. However, development of a smaller tract adjacent to an existing PUD Overlay Zone, may be permitted, if the proposed development conforms to and extends the original development.
(J) Height,
, and setback regulations. Requirements shall be as approved in the Stage I development plan.
(L)
, walls, and
. The location, height, and type of all
, walls and
shall be as approved in the Stage I development plan.
(M) Erosion and sedimentation control. Effective erosion and sedimentation controls shall be planned and applied in accordance with § 154.042.
(N) Common open space;
area. At least 20% of the total acreage of the proposed PUD shall be retained as common open space and
area, and dedicated to a public and/or private entity for operation and maintenance. Such open space and
areas shall be physically situated so as to be readily accessible, available to, and usable by all residents of the PUD. Common open space and
area shall be that part of the total project exclusive of
, streets, parking areas, single-family
, commercial areas, and other non-open space and non-recreationally oriented facilities.
(O) Amendments. Any amendments to plans shall be made in accordance with the procedure required by this chapter, subject to the same limitations and requirements as those under which such plans were originally approved.
(P) Expiration. Any amendment to PUD Overlay Zone shall be subject to the time constraint, as noted below. Upon expiration of said time period, and any extensions thereto, the legislative body may initiate a request for a public hearing by the
, in accordance with the requirements of KRS Chapter 100, for the purpose of determining whether said PUD Overlay Zone should revert to its original zoning designation. A public hearing may be initiated if either of the following conditions apply:
(1) A Stage II development plan has not been approved by the
within a period of 12 consecutive months from the date of the Stage I approved development plan and PUD Overlay Zone amendment by the legislative body; provided that an extension may be permitted upon approval of the legislative body or their duly authorized representative if sufficient proof can be demonstrated that prevailing conditions have not changed appreciably to render the Stage I approved development plan obsolete.
(2) Substantial construction has not been initiated within a period of 12 consecutive months from the date of approval of the Stage II development plan by the
; provided that an extension may be permitted upon approval of the legislative body or its duly authorized representative if sufficient proof can be demonstrated that the construction was delayed due to circumstances beyond the applicant's control, and that prevailing conditions have not changed appreciably to render the Stage I approved development plan obsolete. The amount of construction constituting initiating substantial construction shall be as approved in the Stage I approved development plan.
(Ord. 0-11-82, passed 11-3-82) Penalty, see § 154.999