18.120.060    FLOOR AREA RATIO, RESIDENTIAL DENSITY AND STRUCTURAL HEIGHT.
   The maximum floor area ratio, residential density and structural height for each Development Area is shown in Table 120-E. Special provisions are referenced in the “Special Provisions” column.
   .010   Floor Area Ratio Exception. An increase in the maximum floor area ratio is permitted in connection with a conditional use permit, as set forth in Chapter 18.66 (Conditional Use Permit) and subject to the following additional finding:
      .0101   The proposed use of the structure(s) shall not create a greater impact to infrastructure than impacts anticipated by the maximum permitted floor area ratio, as analyzed by Environmental Impact Report No. 348 prepared for the Anaheim Canyon Specific Plan, unless such impacts are duly analyzed and mitigated pursuant to subsequent environmental review. Such impacts shall be determined through a sewer and traffic impact analysis to be submitted to the City Engineer. Additional infrastructure studies may be required as determined by the Planning Director.
   .020   Structural Height Exceptions. Projections above the height limit are permitted as set forth in Section 18.40.030 in Chapter 18.40 (General Development Standards).
 
Table 120-E
MAXIMUM FLOOR AREA RATIO AND STRUCTURAL HEIGHT BY DEVELOPMENT AREA
DA-1
DA-2
DA-3
DA-4
DA-5
DA-6
Special Provisions
Floor Area Ratio
0.50
0.50
3.0
0.45
0.50
0.10
An increase in Floor Area Ratio may be permitted subject to the approval of a Conditional Use Permit per Section 18.120.060.010.
Residential Density
N/A
N/A
60 dwelling units/ acre
N/A
N/A
N/A
Subject to 18.32.040
Structural Height
60 feet
60 feet
100 feet
60 feet
60 feet
30 feet
Minimum ground-floor height for all commercial, office and mixed-use buildings shall be 15 feet
 
(Ord. 6358 § 9 (part); February 9, 2016.)