CROSS REFERENCES
District regulations - see P. & Z. Ch. 1120
Land Use Tables - see P. & Z. Ch. 1122
District/ Overlay | Lot Minimum | Maximum Height of Structures (a) | Minimum Setback Requirements (Per Lot in Feet) | Minimum Floor Area | Maximum Lot Coverage | |||||
Area (square feet) | Width (feet) (c) | In Stories | In Feet | Minimum Front Yard | Side Yards (b) | Rear Yard | ||||
Least One | Total of Two | |||||||||
R-1, Single-Family Residential District | 8,400(d) | 60(d) | 2 | 35 | 40 (d, e) | 5 (d) | 15 (d) | 40 | (i) | 25% |
R-2, Multiple Family Residential District | 8,400(d) | 60 (d) | 3 | 45 | 40 (d, e) | 5 (d) | 15 (d) | 40 | (i, j, k) | 25% |
B-1, Downtown Commercial District | (g) | (g) | 4 | 60 | 0 (f, g) | 0 (f, g) | 0 (f, g) | 0 (f) | (i, j, k) | 100% |
B-2, Thoroughfare Commercial District | (g) | (g) | 2 | 45 | 0 (f, g) | 10 (f, g) | 20 (f, g) | 10 (f) | (i) | 75% |
B-3, Mixed Commercial District | (g) | (g) | 3 | 45 | 0 (f, g) | 10 (f, g) | 20 (f, g) | 10 (f) | (i, j, k) | 75% |
B-4, Office Service District | (g) | (g) | 2 | 35 | 0 (f, g) | 10 (f, g) | 20 (f, g) | 10 (f) | (i, j, k) | 75% |
I-1, Light Industrial District | ( g) | (g) | 3 | 45 | 30 (f, g) | 10 (f, g) | 25 (f, g) | 10 (f) | -- | 75% |
I-2, Heavy Industrial District | (g) | (g) | 4 | 60 | 30 (f, g) | 10 (f, g) | 25 (f, g) | 10 (f) | -- | 75% |
OS, Open Space District | -- | -- | 2 | 35 | 50 (h) | 15 (h) | 35 (h) | 60 (h) | -- | 5% |
PRD, Planned Res. Development | (l) | (l) | (l) | (l) | (l) | (l ) | (l) | (l) | (l) | (l) |
PUD, Planned Unit Development | (m) | (m) | (m) | (m) | (m) | (m) | (m) | (m) | (m) | (m) |
FOOTNOTES TO SCHEDULE OF REGULATIONS
(a) Additional building height may be permitted in all districts except R-1 and OS with Commission approval, in accordance with the provisions outlined in this Ordinance.
(b) In all districts, on a corner lot, the side yard abutting the secondary street shall be 20 feet.
(c) In all districts, in addition to meeting minimum lot width requirements, each lot shall also provide lot frontage, per Sec. 1130.05, conforming to the provisions of this Ordinance.
(d) For a nonresidential use in an R-1 or R-2 District, lot minimum (area and width) and minimum front and side yard requirements shall be determined by the ability of a proposed use to meet all other requirements of this Ordinance.
(e) In an R-1 or R-2 District, if residences have been constructed on more than 50 percent of the lots along a street frontage between two successive intersecting streets at the time this Ordinance is adopted, the average of the distances between the front lot lines and the nearest walls of buildings on all such lots upon which residences exist fronting on the street shall be the minimum front yard requirement for subsequent construction. See figure below:
The average front yard for lots 1 and 2 equals the sum of the existing front yards for lots a, b, c, and d divided by the number of lots; four in this case.
(f) In a B-1, B-2, B-3, B-4, I-1 or I-2 District, where a lot abuts land in an R-1 or R-2 District, any yard abutting such land shall be increased to 20 feet.
(g) In a B-1, B-2, B-3, B-4, I-1 or I-2 District, lot minimum (area and width) and minimum front and side yard requirements shall be determined by the ability of a proposed use to meet all other requirements of this Ordinance
(h) In an OS District, there shall be no setback requirements for any lot line that abuts another lot in an OS District.
(i) Single-family dwellings shall comply with the following minimum floor area requirements:
Dwellings with or without basement 1,000 sq. ft.
(j) Two family dwellings shall comply with the following minimum floor area requirements per unit:
Dwellings with or without basement 800 sq. ft.
(k) Multiple family dwellings shall comply with the following minimum floor area requirements per unit:
Unit with one bedroom 400 sq. ft.
Unit with two bedrooms 550 sq. ft.
Unit with three or more bedrooms 700 sq. ft.