After completion of all public improvements and prior to the release of the maintenance bond on the improvements, the subdivider shall provide "as built" plans as follows:
(A) "As built drawings" will be required on all improvements that are to be dedicated to, and accepted by, the town for inclusion in the public infrastructure; or will in any way impact any part of the existing public infrastructure.
(B) "As built" or record drawings of any sewer construction, sanitary or storm, in the town shall be provided to the Town Engineering Consultant and Town Zoning Administrator upon completion of and prior to the town's acceptance of the project. As-built drawings shall be submitted on plan and profile sheets in digital format (AutoCAD and PDF formats), as well as typical hard copies (24" x 36" inch formats). Three hard copies shall be submitted to the town.
(C) Requirements for "as-built" or record drawings are as follows:
(1) Each sheet must be signed and sealed by a licensed professional engineer and/or licensed professional land surveyor.
(2) All elevations given on as-builts shall be per NAVD 88 (North American Vertical Datum).
(3) Invert and casting elevations of all structures (i.e., manholes, catch basins, inlets, and the like) shall be provided. Casting elevations on catch basins and inlets shall be shown at the flow line.
(4) The percent of line slope between structures, and/or between structures and stubs shall be shown.
(5) The horizontal location of sanitary laterals, storm laterals and/or taps shall be indicated from the downstream manhole.
(6) The length of the sanitary laterals and/or storm sewer laterals and/or taps from mainline sewer including the elevation of the laterals at the property/right-of-way line and offsets shall be shown.
(7) The location of all structures (i.e., manholes, catch basins, inlets, and the like) shall be shown by stationing.
(8) The locations and sizes of other existing utilities, including but not limited to communications and signals, fiberoptic, telephone, electric, gas and water shall be shown.
(9) The locations of all right-of-way, easement and property lines shall be provided. When service taps have been installed, all property information shall be shown (i.e., lot #, address, property owner name).
(10) If horizontal location of sewer is per plan, place a check mark (√) followed by the words "per plan" next to structure on plan section of sheet. Example: MH #1 (√) per plan STA 1 + 00/10 RT, Line 'M'.
(11) If vertical location of sewer is per plan, place a check mark (√) followed by the words "per plan" next to invert elevation of structure indicated on profile section of sheet.
(12) If line slope of sewer is per plan, place a check mark (√) followed by the words "per plan" next to line slope information of profile section of sheet. Example: 360 LFT - 30 sanitary sewer @ 1.00% per plan.
(13) Any changes on horizontal and vertical location of sewers and any changes of percent of line slope must be shown on plan and profile sections.
(14) All information on "as-built" or record drawings must be neat, concise, and legible.
(15) Indicate the composition of pipe (i.e., clay, RCP, DIP, and the like) on profile section of sheet for each run. A "run" being a section of pipe between structures or between structures and stubs.
(16) Any other information or data requested by town personnel must be included if requested.
(Ord. 27, § 4.30.20, passed 4-16-1997; Am. Ord. 172, passed 6-17-2010; Am. Ord. 191, passed 6-15-2010; Am. Ord. 41I, passed 2-15-2010; Am. Ord. 27A, passed 7-23-2013) Penalty, see §10.99