(A) Compliance date report. Within 90 days following the date for final compliance with applicable pretreatment standards or, in the case of a new source, following commencement of the introduction of wastewater into the P.O.T.W., any user subject to pretreatment standards and requirements shall submit to the Superintendent a report indicating the nature and concentration of all pollutants in the discharge from the regulated process, which are limited by pretreatment standards and requirements, and the average and maximum daily flow for these process units in the user facility, which are limited by the pretreatment standards or requirements. The report shall state whether the applicable pretreatment standards or requirements are being met on a consistent basis and, if not, what additional O&M and/or pretreatment is necessary to bring the user into compliance with the applicable pretreatment standards or requirements. This statement shall be signed by an authorized representative of the industrial user and certified to by a qualified professional.
(B) Periodic compliance reports.
(1) Any user subject to a pretreatment standard, after the compliance date of the pretreatment standard or, in the case of a new source, after commencement of the discharge into the P.O.T.W., shall submit to the Superintendent during the months of June and December, unless required more frequently in the pretreatment standard or by the Superintendent, a report indicating the nature and concentration of pollutants in the effluent which are limited by the pretreatment standards. In addition, this report shall include a record of all daily flows which during the reporting period exceeded the average daily flow reported in division (A) above. At the discretion of the Superintendent and in consideration of factors such as local high or low flow rates, holidays, budget cycles, and the like, the Superintendent may agree to alter the months during which the above reports are to be submitted.
(2) The Superintendent may impose mass limitations on users which are using dilution to meet applicable pretreatment standards or requirements, or in other cases where the imposition of mass limitations are appropriate. In those cases, the report required by this section shall indicate the mass of pollutants regulations by pretreatment standards in the effluent of the user. These reports shall contain the results of sampling and analysis of the discharge, including the flow and the nature and concentration, or production and mass where requested by the Superintendent, of pollutants contained therein which are limited by the applicable pretreatment standards. The frequency of monitoring shall be prescribed in the applicable pretreatment standard. All analysis shall be performed in accordance with procedures established by the administrator pursuant to § 304(g) of the Act and contained in 40 C.F.R. pt. 136, and amendments thereto or with any other test procedures approved by the administrator. Sampling shall be performed in accordance with the techniques approved by the administrator.
(C) Sampling or analytical technique. Where 40 C.F.R. pt. 136 does not include a sampling or analytical technique for the pollutant in question, sampling and analysis shall be performed in accordance with the procedures set forth in the E.P.A. publication, Sampling and Analysis Procedures for Screening of Industrial Effluents for Priority Pollutant, April, 1977, and amendments thereto, or with any other sampling and analytical procedures approved by the administrator.
(1983 Code, § 17-104) (Ord. passed 9-13-1988)