(A) Village design standards. All public improvements, whether performed by the village or its designee or the owner or developer of any property in the village, shall be designed and constructed in accordance with the following provisions of the Village Design Standards for the Village of Webberville, Ingham County, Michigan, May 14, 2008, prepared by Ledy Design Group the terms of which are specifically incorporated by reference as if restated in their entirety:
Section | Page |
Section | Page |
General information and general construction requirements | 1-1 to 1-5 |
Sanitary sewer systems | 2-1 to 2-10 |
Sanitary force mains and lift stations | 3-1 to 3-8 |
Water main | 4-1 to 4-11 |
Storm water management | 5-1 to 5-2 |
Special provisions | 6-1 to 6-9 |
Streets and roadways | 7-1 to 7-10 |
Soil erosion and sedimentation control | 8-1 to 8-2 |
Sample municipal agreement | 9-1 to 9-9 |
Standard construction details | 10-1 to 10-11 |
(B) Effective date. This section shall take effect immediately upon publication.
(C) Driveway approaches. Section VII of the Village of Webberville Design Standards is amended to read as follows:
4. Driveway Approaches - All driveway approaches between the curb and gutter or edge of pavement and the right-of-way shall be concrete or bituminous. Concrete driveway approaches for residential sections shall be six inches (6”) thick and ten inches (10”) thick for commercial driveways. Bituminous driveways shall conform to the pavement cross sections for road design. The maximum grade on driveway approaches shall be ten percent (10%) and the minimum grade shall be one-half percent (0.50%) unless site conditions dictate otherwise.
A driveway culvert may be required as site conditions dictate. Driveway culverts shall meet the requirements of the Ingham County Road Commission.
A separate permit for driveway approaches must be obtained from the Village prior to commencing construction. All elements of the driveway permit shall be adhered to.
A. Residential Driveways:
i. The number of residential driveways that may be permitted shall be determined as follows:
a. One residential driveway for each platted lot.
b. One residential driveway for each unplatted residential property with less than 100 feet of frontage.
c. Additional driveways may be permitted by special request for property with more than 100 feet of frontage provided that the driveways are at least 45 feet apart edge to edge.
d. Corner lots may have access points on more than one street subject to the appropriate setback criteria.
ii. Residential driveways shall be a minimum of ten feet (10’) to a maximum of twenty-four feet (24’) in width.
iii. Residential driveways must be a minimum of five feet (5’) from any side lot line and shall be set back a minimum distance of twenty-five feet (25’) from any street intersection measured from the closest point of the driveway approach to the closest right-of-way line of the intersecting street.
iv. The dimensions of a residential driveway shall conform to Exhibit 1 and Exhibit 2 included in Section X of these standards.
B. Commercial Driveways:
Requirements for commercial driveways shall conform to the requirements described in the Ingham County Road Commission “Rules, Standards and Procedures for Driveways, Banners and Parades Upon or Over Ingham County Road Commission Right-of-Way.”
(Ord. 204, passed 10-20-2008; Ord. 208, passed 11-9-2009) Penalty, see § 151.99