(A) When any electrical hazards are identified, such conditions shall be abated. All identical hazardous electrical conditions in permanent wiring shall be brought to the attention of the electrical code official.
(B) Illumination shall be provided for all service equipment areas, motor control centers and electrical panelboards.
(C) Clearance of not less than 30 (762 mm) shall be provided between all electrical service equipment and storage.
(D) The use of multiplug adaptors, such as cube adaptors, unfused plug strips or any other device that does not comply with NFiPA 70 shall be prohibited.
(E) Extension cords (flexible cords) shall not be used as a substitute for permanent wiring. Extension cords and flexible cords shall not be affixed to structures, extended through walls, ceilings or floors, or under doors or floor coverings, nor shall such cords be subject to environmental damage or physical impact.
(F) Open junction boxes and open wiring splices shall be prohibited. Approved covers shall be provided for all switch and electrical outlet boxes.
(G) Electrical appliances or fixtures shall not be made available for use or used unless such appliances or fixtures are listed by an approved agency. The approved agencies are Underwriters Laboratory and Factory Mutual.
(H) All electrical motors shall be maintained free from excessive accumulations of oil, dirt, waste and debris.
(1974 Code, § 92.05) (Ord. 36-92, passed 6-15-1992) Penalty, see § 92.99