All subdivisions for which Preliminary Plats were required shall submit Final Plats consistent with the requirements of these Regulations to the Planning Commission for review. The Final Plat shall conform in all important details with the Preliminary Plat as approved and any conditions specified in the approval of the Preliminary Plat shall be incorporated in the Final Plat. The following materials shall be submitted with an application for review and consideration of Final Plats:
(a) Final Plat Requirements. Seven (7) copies of the Final Plat in the form of a map or series of maps on sheet size twenty-four (24) inches by thirty-six (36) inches drawn to a scale of fifty (50) feet to the inch. The error of closure shall not be more than one (1) part in ten thousand (10,000). Plats shall show the following:
(1) Title block, including the name and address of the landowner and the name of the proposed subdivision;
(2) Northpoint for the subdivision;
(3) Graphic scale as well as written scale;
(4) Deed book and page number of the tract or tracts being subdivided, and the location of the subdivision by section, township and range;
(5) Municipal corporation and township lines;
(6) Tract boundaries showing accurate bearings and distances;
(7) The names, addresses, deed book and page numbers of owners of all adjacent lands;
(8) Accurate location, width, grade and purpose of all proposed streets, access drives, rights-of-way, easements, parking areas and loading and unloading areas;
(9) Complete curve data including radius, delta angle, tangent, degree of curvature and length of curve of all proposed streets;
(10) Proposed lot lines with dimensions to the nearest hundredth foot and bearings to the nearest degree, minute and second, including a numbering system to identify each lot, and accurate area of the lots proposed;
(11) An indication of the exact location of proposed water lines, sanitary sewer lines, and storm water collection and retention facilities. The final size of each line must be shown as well as the locations of and distances to any existing line to be connected to, with the size of such existing line to be indicated;
(12) Site data to include proposed use or uses, number of lots, total acreage of lots being subdivided, number of acres in the total tract, number and type of dwelling units and/or structures including the gross residential density and the present zoning classification, if applicable;
(13) Location map at a scale not smaller than two thousand (2,000) feet to the inch, including a northpoint, showing the proposed subdivision and adjoining areas sufficient to denote the proposed location;
(14) Location and material of all permanent monuments and lot markers;
(15) Building setback lines on all lots and parcels, and other sites at not less than the minimum fixed by the Zoning Code;
(16) Proposed public buildings, location of screening, active play areas and parcels of land that are to be reserved for public use and common open space, if any; and
(17) Any pedestrian ways or sidewalks that may be required or provided.
(b) Additional Supplemental Requirements. The Final Plat shall be accompanied by the following material where applicable. These plans and design may be submitted as separate sheets.
(1) Such certificates of approval from other agencies as may have been required by the Planning Commission;
(2) Four (4) copies of final detailed profiles and typical cross-sections of all existing and proposed streets indicating street grades, width of right-of-way, width of cartway, and location and width of sidewalks, if required, including curbs and shoulders;
(3) Four (4) copies of final detailed plans and profiles of all existing and proposed sanitary and storm sewer systems, water distribution systems and other pertinent underground utilities. Such plans and profiles shall include grades, pipe sizes, and the location of manholes, valves and fire hydrants;
(4) Four (4) copies of all final detailed designs of all bridges, culverts, storm water management facilities, and soil erosion and sedimentation control facilities or other improvements as may be required, including calculations; and
(5) Four (4) copies of all proposed deed restrictions or lease provisions related to the approval of the proposed subdivision plat.
(c) Certificates. The following certificates in block form shall be shown on the Final Plat where applicable:
(1) Certification by means of a seal and signature of the Professional Surveyor who shall have prepared the plat and certify to the effect that the survey and plat are accurate and correct;
(2) Certificate for approval by the Planning Commission;
(3) A statement, duly acknowledged before an officer authorized to take acknowledgments of deed and signed by the owner or owners of the property, to the effect that the subdivision as shown on the Final Plat is the act and deed of the owner, and that he/she (the landowner) is the owner of the property of the survey and plat, and that he/she desires the same to be recorded as such; and
(4) Certificate indicating approval for water supply and sewage disposal to be utilized, consistent with the requirements of Chapter 1119 of these Regulations.
(5) Certificate for acknowledgment of easements.
(d) Design Standards. The subdivision shall be designed pursuant to the standards contained within Chapter 1119
of these Regulations, the City Zoning Code and other applicable Codes and Regulations.