The following drawing standards are hereby established:
(A) Preliminary plats and construction drawings shall conform to the following:
(1) Plat size: 18 inches x 24 inches.
(2) Letter size: Minimum 1/8-inch.
(3) Letter spacing: Minimum 1/16-inch or half of the letter size used.
(B) Final record plats shall conform to the following:
(1) Plat size: 24 inches x 38 inches.
(2) Letter size: Minimum 3/16-inch.
(3) Letter spacing: Minimum 3/32-inch or half of the letter size used.
(C) For both size plats, the minimum spacing between lines will be that of the letter size.
(D) All plats shall have a two-inch border.
(E) Letter quality shall be as follows:
(1) Technical pens will be used.
(2) Smaller letters and numbers will be made with a fine tip pen (usually a pen numbered between zero and two).
(3) Letters and numbers will be well-defined and will not run or bleed.
(F) Material for the reproducible copy shall be black India ink on mylar.
(G) The condition of plats shall be as follows:
(1) No numbers or letters will be drawn in shaded areas.
(2) Appliques will be on the front side of the plat and meet all other size standards.
(3) Signatures will be in permanent black ink.
(4) Seals will be shaded or in permanent ink.
(5) Folded, wrinkled or torn plats are not acceptable.
(Ord. 09-3306, passed 10-15-09)