(A) The following minimum land areas shall apply in this district:
(1) Each manufactured home residential subdivision shall contain a minimum of five contiguous acres of land and a minimum of ten lots. Development of a smaller tract of land adjacent to an existing manufactured home subdivision may be permitted if:
(a) The proposed development conforms to and extends the original manufactured home subdivision; and
(b) The proposed development otherwise conforms to all of the requirements of this chapter.
(B) Minimum lot area.
(1) The minimum lot area of one-fourth of one acre or more if connected to a public sanitary sewage disposal system; or
(2) The minimum lot area of seven-tenths of one acre or more if connected to an on-site sanitary sewage disposal system approved by the Health Department.
(C) The minimum lot width at building setback line shall be 75 feet.
(D) The maximum lot area coverage with structures and parking shall be 50%.
(E) Yard regulations. The following yard sizes shall apply in this district:
(a) Minimum side yard width to each side lot line shall be ten feet.
(b) Minimum rear yard setback shall be 25 feet.
(c) The minimum front yard setback shall be: one-half width of right-of-way, but in no case less than 25 feet except as provided in this chapter.
(F) Height regulations. No structure shall exceed 35 feet in height, except as otherwise provided in the additional height and area regulations of the residential districts of this chapter.
(G) Parking regulations. Two off-street parking spaces shall be provided for each manufactured home lot.
(H) Sewer requirements. All manufactured homes shall be connected to the public sanitary sewage system or an on-site sanitary sewage disposal system approved by the Health Department.
(I) Water requirements. All manufactured homes shall be connected to the public water supply system.
(J) Street access and design standards.
(1) General requirements. The manufactured home subdivision shall be located with direct to a public street and shall have a minimum of 50 feet of frontage. Entrances and exits for the manufactured home subdivisions shall be designed for safe and convenient vehicular to and from abutting public streets. All traffic into and out of the manufactured home subdivision shall only be through entrances and exits approved under the provisions of this article with a maximum of two points. No entrance or exit for a manufactured home subdivision shall have an intersection angle less than 80 degrees and the radii of curbs and pavements at intersections shall not be less than 35 feet.
(2) The individual lots within the manufactured home subdivision shall not be located with direct to the public streets except those streets within the subdivision approved under this subchapter.
(3) Development involving new or additional streets or any public dedication of land shall be subject to Planning Commission review and approval, as provided in the subdivision regulations.
(K) Development standards. In addition to the standards set forth in this chapter, each manufactured home subdivision shall comply with all appropriate provisions of the subdivision regulations.
(Ord. 665-98, passed 12-21-1998)