A. Preparation: The subdivider shall cause the map to be prepared by a registered civil engineer or licensed surveyor, and such map shall be in full compliance with the requirements of this Section.
B. Form: The map shall be clearly and legibly drawn. The size shall be eight and one-half inches by eleven inches (81/2" x 11") or eleven by seventeen inches (11" x 17"). The scale of the map shall be large enough, not smaller than one inch equals sixty feet (1" = 60'), to show clearly all details thereof, and such map shall contain the following information:
1. The legal description of the entire subdivision and the legal description for each lot, true north point, scale, date of survey, basis of bearings and the subdivision boundary line accurate in scale.
2. Name and address of record owner or owners.
3. Name and address of the subdivider.
4. Name, business address and number of registered engineer or licensed surveyor.
5. Sufficient elevation and contours to determine the general slope of the land and the high and low points thereof.
6. The locations and existing widths of all adjoining and contiguous highways, streets and ways and the tract number or names of adjoining subdivisions.
7. The approximate widths, location and purpose of all existing or proposed easements.
8. Lot layout, dimensions, area in square feet and a number for each lot, which numbering shall start with "1" and be numbered consecutively.
9. The outline of any existing buildings to remain in place and their locations within the subdivision and immediately adjacent thereto, in relation to existing street and lot lines.
10. Approximate location of all areas subject to inundation or storm water overflows and the location, width and direction of flow of all watercourses.
11. The location of political subdivision lines or corporation lines.
12. The precise position, description and character of all monuments found or required to be set.
13. The location of existing sewers, culverts or other underground structures within the subdivision and immediately adjacent thereto, with sizes and grades indicated.
14. The location of proposed sanitary sewers, storm water drains and other public utilities.
15. Sufficient linear, angular and curve data to determine readily the bearing and length of the boundary lines of the subdivision and of the boundary lines of every lot.
16. Arc lengths, radii and total delta or radial bearings of each curve; where lot corners are rounded at street intersections, the tangents thereof.
17. Existing use or uses of the property.
18. Proposed use of the property; if the property is proposed to be used for more than one purpose, the area, lot or lots proposed for each type of use.
19. Statement of the improvements and public utilities proposed to be made or installed and of the time at which such improvements are proposed to be completed.
20. Provision for proposed sewerage and sewage disposal.
21. Tree planting proposal.
22. Approximate location of each area covered by brush or trees with a statement of the nature of such cover and the kind and approximate location of all trees standing within the boundaries of proposed public rights of way.
23. Types and location of street lighting proposed.
C. Owner's Statement: Such of the information listed above as may not practicably be shown on the map shall be contained in a written owner's statement accompanying the same. (1954 Code §20.38)